The short answer
F2 E6 on an oven of this generation means the user interface or keypad or the control and the wiring between them sent the control something it cannot interpret as a keypress. Until the panel reads cleanly the control refuses input, which is why nothing responds. The first thing worth eliminating is steam from the cooktop drawn behind the console.
This code, as the manufacturer publishes it
Reference| Code | Documented meaning |
|---|---|
| F2 E6 | There may be a problem with the User Interface or Keypad, the Control, or the associated wiring. |
What an owner observes
- The panel wakes, shows the code, and locks out — Locking out is the control refusing to act on input it cannot verify.
- The console responds differently when the appliance is hot — Heat expands everything behind the panel, and a marginal contact behaves differently at temperature.
- NEAR MISS - the display is blank and no key responds — That is a supply or board fault, not a keypad fault, and it is a different page.
Causes, and why they rank that way
- Moisture or cleaner behind the panel membrane — Ranked first because it is the cause that cures itself: liquid bridging two traces reads as a held key, and a day of drying with the power off removes it.
- User interface or keypad at the end of its life — Third: membranes wear where they are pressed most, and a worn trace fails intermittently before it fails for good.
The cheapest checks first
- Work out which keys respond and which do not — A pattern tells a technician whether the panel or the board is answering.
- Leave the ribbon and the board to a technician — Both are behind the console, and that is where an owner check ends.
What to try before calling
- Wipe the panel with a barely damp cloth, never a spray — Spray finds the gap at the bezel and puts the fault straight back.
Tools: soft clothAbout 5 min
- Clear everything off and away from the console face — A tea towel over a console is a held key as far as the control is concerned.
About 5 min
- STOP HERE if the console has to come off — The ribbon and the board behind it are service work, and the panel is easy to crease beyond repair.
Safety first, and it is not optional
Safety
Unplug the appliance or switch off its breaker before any panel comes off; a capacitor can hold a charge after the power is off. Everything in the procedure above stays outside the cabinet for that reason. Leave the door switch and the other interlocks exactly as they were fitted - they exist to stop the appliance running when it should not.
Where an owner stops and a technician starts
Call at once if the machine starts a cycle nobody selected. A control acting on presses that were never made should not be left connected. Short of that: call when the panel still misreads after it has dried, or when keys have gone dead permanently: a membrane and a ribbon are both service parts and the panel comes off to reach them.
Other codes on the same appliance
Which model lines this reading applies to
What this page covers is the code as documented for the model lines that use this console layout. It is general information about one reading, not a service manual for your unit: torque figures, connector pinouts and part numbers vary by family and are not printed here for that reason. Where a family-specific or model-specific page exists, it is the closer answer - start there, and use the index below to find it.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
