Want a regional phone & address? Pick your area.
Kenmore·Washermedium severity
Kenmore Washer Error Code F5
Water temperature sensing error
Common Causes
- 1NTC thermistor failure
- 2Hot water supply disconnected
- 3Wiring fault to temperature sensor
Step-by-Step Troubleshooting
- 1
Verify hot water supply valve is open and connected
- 2
Locate NTC thermistor on the outer tub — measure resistance (~10K ohms at room temp)
- 3
Check wiring from thermistor to control board for damage or loose connectors
- 4
If thermistor reads open or near zero, replace the sensor
Pro Diagnostic Tip
Applies to models starting with 110.xxxxx (Whirlpool platform). F5 can appear when only cold water supply is connected — check hot valve before replacing sensor.
You Might Also Notice
- •Cold water wash despite hot setting
- •Water temperature inconsistent
- •Cycle takes longer than normal
Parts, Cost & Difficulty
Repair Difficulty
Moderate — Some Experience NeededEstimated Repair Cost
$75–$200
Parts + labor. Free diagnosis with repair.
Parts That May Need Replacement
W11316256 NTC temperature sensorW11165546 water inlet valve
Do You Have the Right Tools?
Bearing puller set ($120), drum spider wrench ($85), multimeter ($85), and diagnostic software. Our technician arrives with $15K+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Safety First — Know the Risks
High-voltage components and pressurized water lines create flood and shock risk. A single loose fitting can cause thousands in water damage. Our techs are licensed and insured — let them handle the risk.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Ready to Get This Fixed?
Don't let error code F5 disrupt your day. A professional diagnosis takes about 30 minutes — and it's free when you proceed with the repair.
Licensed & Insured · 90-Day Warranty · Same-Day Appointments Available
4.85 (232 verified reviews)
Same-Day Appliance Repair
Fixed or It's Free
Free Service Call & Diagnosis — no hidden fees, offer ends May 31
Frequently Asked Questions
What does Kenmore error code F5 mean?
Kenmore error code F5 indicates: Water temperature sensing error. This is a medium-severity issue affecting your washer.
How do I fix Kenmore error code F5?
Verify hot water supply valve is open and connected Then, Locate NTC thermistor on the outer tub — measure resistance (~10K ohms at room temp) Then, Check wiring from thermistor to control board for damage or loose connectors There are 1 more steps — see the full troubleshooting guide above. This repair typically requires professional tools and expertise.
How do I know if my washer has error F5?
Besides the error code on the display, common signs include: Cold water wash despite hot setting; Water temperature inconsistent; Cycle takes longer than normal. If you notice any of these symptoms, check your washer's display panel for error code F5.
How much does it cost to fix Kenmore F5?
Repair costs for Kenmore F5 typically range from $75 to $200 depending on the specific cause and parts needed. EasyBear offers free diagnosis when you proceed with the repair. Call (415) 795-7300 for a same-day appointment.