Want a regional phone & address? Pick your area.
Kenmore·Washermedium severity
Kenmore Washer Error Code F26
Door switch error
Common Causes
- 1Door switch failure
- 2Door strike misaligned
- 3Wiring to switch damaged
Step-by-Step Troubleshooting
- 1
Check door for obstructions preventing full closure
- 2
Test door switch continuity — should toggle when door is opened/closed
- 3
Inspect wiring harness from door switch to CCU for damage
- 4
If switch tests good but error persists, the CCU door switch input has failed
Pro Diagnostic Tip
The 110-series Kenmore is Whirlpool underneath, and this code means the CCU never sees the door-closed signal — which points at wiring far more often than the switch. Ohm the run from the switch back to the board first; a strike that sits a hair off can also miss the plunger, so check door alignment before ordering parts.
You Might Also Notice
- •The wash will not begin at all
- •The door reads open on the panel though it is plainly shut
- •A repeated tick from the latch area
Parts, Cost & Difficulty
Repair Difficulty
Moderate — Some Experience NeededEstimated Repair Cost
$100–$225
Parts + labor. Free diagnosis with repair.
Parts That May Need Replacement
W11307244 door switch/lock assembly
Do You Have the Right Tools?
Bearing puller set ($120), drum spider wrench ($85), multimeter ($85), and diagnostic software. Our technician arrives with $3,000+ in professional tools — your diagnostic is free.
Book a Free Diagnostic VisitOr call for a free consultation (415) 795-7300Available 24/7 — call or text
Licensed & Insured · 90-Day Warranty · Same-Day Service
Safety First — Know the Risks
High-voltage components and pressurized water lines create flood and shock risk. A single loose fitting can cause thousands in water damage. Our techs are licensed and insured — let them handle the risk.
Let a Licensed Pro Handle ItOr call for a free consultation (415) 795-7300Available 24/7 — call or text
Licensed & Insured · 90-Day Warranty · Same-Day Service
Ready to Get This Fixed?
Don't let error code F26 disrupt your day. A professional diagnosis takes about 30 minutes — and it's free when you proceed with the repair.
Licensed & Insured · 90-Day Warranty · Same-Day Appointments Available
5.00 (36 verified reviews)
Same-Day Appliance Repair
Fixed or It's Free
Free Service Call & Diagnosis — no hidden fees, offer ends Sep 15
Book a Free Diagnostic VisitOr call (415) 795-7300Available 24/7 — call or text
Frequently Asked Questions
What does Kenmore error code F26 mean?
Kenmore error code F26 indicates: Door switch error. This is a medium-severity issue affecting your washer.
How do I fix Kenmore error code F26?
Check door for obstructions preventing full closure Then, Test door switch continuity — should toggle when door is opened/closed Then, Inspect wiring harness from door switch to CCU for damage There are 1 more steps — see the full troubleshooting guide above. This repair typically requires professional tools and expertise.
How do I know if my washer has error F26?
Besides the error code on the display, common signs include: The wash will not begin at all; The door reads open on the panel though it is plainly shut; A repeated tick from the latch area. If you notice any of these symptoms, check your washer's display panel for error code F26.
How much does it cost to fix Kenmore F26?
Repair costs for Kenmore F26 typically range from $100 to $225 depending on the specific cause and parts needed. EasyBear offers free diagnosis when you proceed with the repair. Call (415) 795-7300 for a same-day appointment.
Call NowAvailable 24/7 — call or textBook Online