The short answer
On a Whirlpool oven, F7 E6 is about airflow. The control did not get the cooling-fan behaviour it expected from the cooling fan, and it names the wiring to it in the same line.
Error codes
Reference| Code | Meaning |
|---|---|
| F7 E6 | There may be a problem with the Cooling Fan, or the associated wiring. |
What you see and hear
- The code appears part-way through a hot cycle and the oven shuts the heat off — The control allows the condition for a while, then stops. That is why the code so often lands in the middle of a roast rather than at switch-on.
- Only one function is affected while the rest behave normally — That split places the fault in one circuit rather than in the supply or the main control, and it costs nothing to establish.
- NEAR MISS — the fan runs constantly, long after the oven is off — A run-on fan is designed behaviour, not this fault. It carries residual heat away after the cycle.
Causes, most likely first
- The fan motor or its bearing is failing — Ranked first because it is the part the code names and the part that does mechanical work in the hottest air in the appliance.
- The fan motor or its bearing is failing — A motor drawing heat into a tired bearing slows under load, and slowing is exactly what the control measures.
- The control that drives or monitors the fan has failed — Last: it is the least likely and the most expensive, and it is only worth considering once the airway is clear, the motor turns freely and the circuit reads correctly.
Check in this order, and why
- Check the airway first, because it is free and it is common — Look at the vent the oven exhausts through, usually above the door or under the control panel, and at the intake beneath or behind the appliance.
- Check whether more than one code is stored — Where several codes from one family appear together, they are usually a single fault reported from several angles rather than several problems.
- Measure the feed and the feedback at the control connector — This separates a fan that was never told to run from one that was told and could not.
What an owner can safely do
- Cut power at the breaker for a full minute, then restore it — It clears the stored code so you can see whether the fault returns on the next run, and on airflow codes it also lets an over-temperature condition fall back to normal before you test again.
About 5 min
- Note which functions still work and which do not — Work through each one in turn and write the results down. That map narrows the fault more than the code number can.
About 15 min
- STOP HERE if the next step needs a meter on live terminals or a panel off — That is the line between an owner check and a service call on this circuit.
Before you open anything
Safety
Unplug the oven or switch off its breaker before any panel comes off. A capacitor can hold a charge after the power is off, and a built-in oven is normally hard-wired, so the breaker is its only disconnect. If your range burns gas and you smell gas: leave the building without switching anything on or off, call the gas utility or emergency services from outside, and do not look for the leak yourself.
When to call a technician
Call once the airway is clear and the code still appears, or immediately if the fan makes no sound at all during a run.
Neighbouring codes on this appliance
What this page does not cover
This page reads F7 E6 as Whirlpool documents it for ovens in this range, so it covers the appliance class rather than one model line: a wall oven, a range and a microwave-oven combination can all post it with different hardware behind the panel. Where a family- or model-specific page exists for your unit it is the more specific answer, and it is linked from the code index below.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
