The short version
This code says the reading arriving from the sensor or the appliance control board and the wiring between them fell outside the band the control is built to trust. The machine protects itself by refusing to heat on an unverified reading, which is why the cycle ends early.
What this code is documented as meaning
Reference| Code | Documented meaning |
|---|---|
| E62 | The Oven Sensor circuit reported a shorted condition to the control board. There may a problem with the Sensor, the Appliance Control Board, or the associated wiring. |
The behaviour that comes with this code
- The code appears and the cycle stops heating — Everything else looks normal — lights, fan, display — and only the heat is missing.
- Temperature drifts, or the display disagrees with the food — A probe reading a few ohms off is still inside its window, so the cabinet runs cool or hot before the code ever latches.
- NEAR MISS - nothing heats and no code shows at all — That is a power or element fault rather than a reading fault, and it belongs on the page for that symptom.
What produces this code, likeliest first
- A loose or corroded connector at the sensor — Ranked first because it is the failure that needs no part: the probe is fine, the joint carrying its signal is not, and heat cycling at the back of the cavity is what works a pin loose.
- A chafed or pinched harness between the probe and the board — Third: a wire rubbed through against sheet metal reads exactly like a failed probe from the board's side, which is why the harness is checked before the board is condemned.
The order to work through it
- Look at the connector at the sensor before anything is measured — Seated, clean and tight is a five-second answer to the most likely cause.
- Compare what the appliance claims against a separate thermometer — Ten minutes with an oven thermometer separates a drifting probe from a control that is being told the truth.
What to try before calling
- Clear the code with a full power-down — Switch the breaker off, let the control lose its stored state, then switch it back on and start a short cycle.
About 5 min
- Run the shortest cycle the appliance offers and watch for the code — A short cycle that stays clean while a long one fails tells a technician the fault is thermal.
About 20 min
- STOP HERE if the next step is a meter across the probe terminals — That means a panel off and a connector back-probed, which is where an owner check ends and a service call begins.
What to do before any panel comes off
Safety
Unplug the appliance or switch off its breaker before removing any panel - a capacitor can hold a charge after the power is off. Leave every switch and interlock wired as the manufacturer fitted it: they are what stops the appliance running in a state it should not.
Where an owner stops and a technician starts
Where an owner stops: call once the code survives a full power-down: a repeatable reading fault is a probe, a harness or a board, and telling those three apart needs a meter and the resistance table for that model line. And where nobody should wait at all: call straight away if you smell hot insulation or see discoloured wiring at the back — a connector hot enough to discolour is arcing, and that is a different and more urgent problem than the reading the code named.
Other codes on the same appliance
Which model lines this reading applies to
What this page covers is the code as documented for the model lines that use this probe on this cavity. Where a family-specific or model-specific page exists, it is the closer answer - start there, and use the index below to find it.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
