The short answer
On this oven the code 1c6c reports that the oven control and its wiring did not answer the control's own self-check. Expect it to work briefly after a reset; a fault that returns is not a fault a reset fixed.
This code, as the manufacturer publishes it
Reference| Code | Documented meaning |
|---|---|
| 1c6c | There may be a problem with the Oven Control, or the associated wiring. |
What an owner observes
- The display lights but the machine will not start a cycle — Buttons respond, the code stands, and nothing commits.
- The appliance works after a reset and fails again days later — An interval measured in days points at heat and vibration rather than at a dead component.
- NEAR MISS - the panel is completely dark — No display at all is a supply or a low-voltage fault, and it is a different page.
What is usually behind it
- A supply disturbance that left the control latched — First because it is the only cause on this list an owner can clear: the board is fine, its stored state is not, and a full power-down is the whole repair.
- Oven control itself — Third, and genuinely third: boards do fail, but they fail far less often than the supply events and the plugs above them.
The check order this code implies
- Power the machine down at the breaker and bring it back — Free, and it separates a latched state from a hardware fault before any panel comes off.
- Check that the machine is on its own circuit and the plug is sound — A shared or failing circuit produces board faults that are not board faults.
What an owner can safely do
- Start a short cycle and watch for the code to return — Whether it comes back, and how fast, is the single most useful thing you can tell a technician.
About 20 min
- Keep a note of every code and when it appeared — Two codes with a pattern are worth more to a technician than one code with none.
About 5 min
- STOP HERE - do not open the control housing — Board work means live low-voltage rails behind a panel, and the diagnosis needs the wiring diagram for that model line.
Before you open anything
Safety
Power off at the breaker or at the plug before any panel is removed - a capacitor can hold a charge after the power is off. The owner-side checks on this page need no panel removed at all. If you get as far as wanting a meter on something, that is the point to call rather than the point to improvise.
When a reset is not the answer
Where an owner stops: call when the code returns after a full power-down, or returns a second time: a repeating control fault is diagnosed with the wiring diagram for that model line and is not an owner repair. And where nobody should wait at all: call immediately if you see scorching at a connector or smell hot plastic near the console — that is an arcing joint, not the communication fault the code names.
The nearest codes in this set
Which model lines this reading applies to
This is generalized information about one code across the model lines that carry this control on this platform. It does not carry the numbers that belong to a specific unit: wiring colours, resistances and part numbers are family-specific, and they are the reason a service manual exists. If your family or model has its own page, read that one first - it is the more specific answer - and the code index below is where to look for it.
The code index and nearby reading
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
