In one paragraph
A dishwasher has a small number of failure modes, and most of them are about what the filter collects, what the plumbing under the sink is doing, and whether the water is hot enough. A dealer and rent-to-own brand with a long production life and an unknown service history. This page ranks the classes for a long-service machine in a settled installation, where the consumables and the wearing parts come first; a freshly installed unit ranks differently.
What the machine is doing
- Dishes are cold and greasy at the end — A machine that stopped heating still completes its cycle, so it hides. See “Not Heating”. — Slug: crosley-dishwasher-heating-failure-2
- Water is standing above the filter at the end — The drain path runs through the filter, the hose loop, often an air gap and often a disposer. See “Will Not Drain”. — Slug: crosley-dishwasher-drainage-failure-2
- Grit, film or wet dishes at the end — Blocked spray jets, a greasy filter and loading account for most of it. See “Does Not Clean or Dry”. — Slug: crosley-dishwasher-cleaning-performance-2
- A sour smell when the door opens — The filter, sump and gasket hold residue in standing water. See “Odor or Mold”. — Slug: crosley-dishwasher-smell-mold-2
- It stops part-way, often with water inside — See “Cycle Will Not Run or Complete”. — Slug: crosley-dishwasher-cycle-fault-2
- Knocking, grinding or buzzing during a cycle — See “Abnormal Noise or Vibration”. — Slug: crosley-dishwasher-abnormal-noise-2
- Nothing happens when start is pressed — See “Will Not Start or No Power”. — Slug: crosley-dishwasher-wont-start-2
- A tripping breaker or a hot smell — See “Electrical, Fire or Gas Hazard”. — Slug: crosley-dishwasher-electrical-safety-2
- Water at the door or damp under the cabinet — See “Water Leak”. — Slug: crosley-dishwasher-water-leak-2
- Steam at the door edge, or a door that will not latch — See “Door, Latch or Seal Fault”. — Slug: crosley-dishwasher-door-seal-2
- A code, a flashing pattern or a dead panel — See “Controls, Display or Error Code”. — Slug: crosley-dishwasher-control-fault-2
Likely causes in order
- No hot water — Ranked first on this brand: on a machine that has been in the same place for years, the parts that have been moving all that time are where the fault usually is. The element sits in the sump and scales or fails, and detergent chemistry stops working without heat. There is no counted denominator behind this order — it ranks by how the platform is built and used, not by a measured share.
- Water that will not drain — Ranked second: The filter collects everything that comes off the dishes, and half the drain path is plumbing rather than appliance.
- Dishes that come out dirty — Ranked third: Water has to reach every surface and it has to be clean when it gets there; both fail through neglect rather than breakage.
The fault profile — No counted denominator exists for Crosley dishwashers in this program's fact bundle, so this table carries no share and no sample size: the order is ordinal and editorial, not a measured proportion of any corpus.
General guidance| Problem class | How often it turns up | The tell-tale |
|---|---|---|
| No hot water | most often | Everything is wet as well as greasy |
| Water that will not drain | often | The pump runs with nothing moving |
| Dishes that come out dirty | sometimes | A spray arm that will not spin by hand |
| Odour | sometimes | The filter smells when lifted out |
When this becomes a service call
The filter, the spray arms, the door gasket, the supply valve, the drain hose loop and the air gap are all owner work, and between them they account for most dishwasher complaints. Anything that needs the machine pulled out of the cabinet is a service call, and any trip, burning smell or tingle is a call made straight away. Unplug the appliance or switch off its breaker before removing any panel. A capacitor can hold a charge after the power is off.
The same machine, other symptoms
How specific this page is
Everything above is generalized across the Crosley dishwasher range rather than tied to a model. Nothing more specific exists to send you to at the moment; a model-level page, once written, is linked here and is the better answer. Deliberately not here: the step-by-step diagnosis for any one fault — each class above has its own page.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
