The short answer
A leaking Costway FP Washer almost never has a cracked tub. The ordinary causes are the fill hoses at the back, too much detergent, a door or lid seal that has hardened, and a pump housing or internal hose clamp that has let go — in that order of likelihood.
What you see on the FP family
- Water on the floor behind the machine — Supply hoses, their washers, or the drain hose connection. It is the most common place for washer water to appear.
- Water at the front of the machine during the wash — The door or lid seal, or foam escaping past it, rather than a plumbing connection.
- Foam pushing out of the dispenser or the door — Over-sudsing, usually too much detergent or the wrong type for the machine. The machine is fine and the chemistry is not.
- Water appears only during the drain step — The pump housing, its clamp or the drain hose connection, all of which are pressurised only at that moment.
Causes, most likely first on the FP family
- Fill hoses, washers and their connections — Ranked first on the FP family — water at the back on the Costway FP washer family is this until proven otherwise, and it is visible once the machine is pulled out. Rubber fill hoses age, their washers flatten, and the connections loosen with vibration. The result is a slow weep at the back that grows between uses rather than during them.
- Over-sudsing from too much or the wrong detergent — Second — and free to rule out: run one cycle with no detergent and see whether the leak repeats. Excess foam finds every route out of the tub, including the dispenser and the door seal. It looks exactly like a failed seal and it is not a fault at all.
- Door or lid seal hardened, torn or fouled — Third — visible, cleanable and replaceable, and the usual answer when the water is at the front. A seal that has taken a set no longer conforms to the glass or the rim, and grit or a bra hook trapped in the fold holds it open at one point. Water then escapes at exactly that point every cycle.
- Pump housing, internal hose clamps or the tub seal — Fourth — and the only group on this page that is not owner work on these models. The internal hoses are clamped rather than threaded and a clamp that has relaxed leaks only when that hose is pressurised. A tub seal failure appears under the machine during the spin and is the serious end of the list.
- Body: The order below follows the shared parts rather than the differences — the stems in the FP family carry the same running gear and diverge at the cabinet — which is why the top of this list is not where the brand-generic article puts it.
Check in this order, and why
- 1. Dry the floor completely and note where the water returns — Front, back, or under the middle. That single observation removes most of the candidate list.
- 2. Run one cycle with no detergent at all — If the leak disappears, it was suds. This is the cheapest decisive test on the page.
- 3. Pull the machine out and look at the fill hose connections — Dry paper towel under each fitting overnight is a better test than looking, and it separates supply from tub.
- Body: The stems in the FP family share their layout, so the order below holds across the table; where a stem differs it differs at the cabinet, not at the part you are reaching for.
Before you open anything
Safety
Unplug the appliance or switch off its breaker before removing any panel — a capacitor can hold a charge after the power is off. Close both taps and drain the tub before moving the machine: a full tub makes a heavy machine unstable. Dry the floor before working on it, and do not run a cycle to reproduce a leak with a panel off.
Models in the FP family
Reference| Model number | Family key |
|---|---|
| FP11187US-GR | costway:washer:fp |
| FP11187US-WH | costway:washer:fp |
| FP11188US-GR | costway:washer:fp |
| FP11188US-WH | costway:washer:fp |
| FP11212US-GR | costway:washer:fp |
| FP11212US-WH | costway:washer:fp |
| FP11213US-GR | costway:washer:fp |
| FP11213US-WH | costway:washer:fp |
| FP11214US-GR | costway:washer:fp |
| FP11214US-WH | costway:washer:fp |
| FP11215US-GR | costway:washer:fp |
| FP11215US-WH | costway:washer:fp |
| FP11216US-GR | costway:washer:fp |
| FP11216US-WH | costway:washer:fp |
| FP11217US-GR | costway:washer:fp |
| FP11217US-WH | costway:washer:fp |
| FP11218US-GR | costway:washer:fp |
| FP11219US-GR | costway:washer:fp |
| FP11219US-WH | costway:washer:fp |
| FP11220US-GR | costway:washer:fp |
| FP11220US-WH | costway:washer:fp |
| FP11221US-GR | costway:washer:fp |
| FP11221US-WH | costway:washer:fp |
| FP11222US-GR | costway:washer:fp |
| FP11222US-WH | costway:washer:fp |
| FP11223US-GR | costway:washer:fp |
| FP11223US-WH | costway:washer:fp |
When to call a technician
On the Costway FP washer family the owner line is the hoses, the detergent and the seal. Those three account for most washer leaks and need no visit. Internal clamps, the pump housing and the tub seal are service work, and a machine leaking onto a live connection should be switched off at the breaker.
Other FP washer pages
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
