What this means on these models
A Comfee CLV washer that will not drain has a blockage far more often than a dead pump. Everything about the drain path here is small-bore, which is why a sock or a handful of lint ends the cycle. Only when the path is proven clear does the pump itself become the suspect.
The observable signs on this platform
- The machine will not spin — Most machines will not spin with water in the drum, so a drain fault reads as a spin fault.
- Standing water that has gone stale — Clearing the filter usually ends the smell.
- Dirty water returning — Check the hose height first when this is the symptom.
- Pump noise and a full drum — It means power is reaching the pump, which is useful information.
- NEAR MISS — nothing happens when it is switched on — A machine that never starts is a different page, and the drum being full is incidental.
Ranked causes for these models
- Debris filling the trap — On a small-capacity drum the filter fills faster than on a full-size machine, so the interval between cleans matters more here.
- The hose looped too low — High here because these machines are light and frequently moved, and the hose is what gets crushed when the cabinet is pushed back.
- A door lock failing to signal — It belongs on this list because a machine that never reaches the drain step looks identical to one that cannot drain.
- Object jammed in the pump impeller — Common wherever pockets are not emptied, which is to say almost everywhere.
The order to work in
- Empty the machine, then open the drain filter — Use the small emergency hose beside the filter if the model has one, rather than opening the cap on a full drum.
- Check the hose for kinks and its height at the waste — Straighten any sag that holds water and secure the hose so it cannot slip down the standpipe.
- Check the pump for a jammed object — Remove any hard object and check the blades are intact before reassembling.
- Check other fixtures for slow drainage — On a sink-drained portable, clear the sink trap first.
What to do before the panel comes off
Safety
Isolate the machine before any panel or filter cap comes off — the drum and the pump both move under power. Wear gloves for the filter chamber if the machine has been standing. Expect water when you open the filter: have towels and a shallow tray ready, and clear the floor first.
Models in the CLV washer family
Reference| Model number | Family key |
|---|---|
| CLV09N1AMG | comfee:washer:clv |
| CLV16N2A** | comfee:washer:clv |
| CLV17N2A** | comfee:washer:clv |
| CLV18N1A** | comfee:washer:clv |
| CLV20N2A** | comfee:washer:clv |
| CLV20N3A** | comfee:washer:clv |
| CLV24N2A** | comfee:washer:clv |
| CLV30N4A** | comfee:washer:clv |
When this stops being a DIY job
Do not run repeated cycles to clear a blockage: each attempt costs the pump. If the same blockage returns within weeks, something upstream is shedding and it needs looking at properly.
Other faults covered for the CLV line
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
