The short answer
A Comfee CL washer that finishes with water in the drum has a blockage far more often than a dead pump. Everything about the drain path here is narrow, which is why a sock or a handful of lint ends the cycle. Only when the path is proven clear does the pump itself become the suspect.
What the owner sees and hears
- A rattle from the pump area — A coin or a button in the impeller makes that sound, and it is usually visible once the filter is out.
- The cycle stalls before spinning — Most machines will not spin with water in the drum, so a drain fault reads as a spin fault.
- A leak that appears only on drain — Deal with the water on the floor before continuing.
- Cycles have got longer — Slow drainage is the early stage of the same blockage, and it is the cheapest moment to fix it.
- NEAR MISS — water escaping at the inlet — A leak that appears during fill is a supply-side fault from a drain blockage.
Ranked causes for these models
- Drain filter full of lint — On a small-capacity drum the filter fills faster relative to its size, so the interval between cleans matters more here.
- A coin, button or clip in the pump — Ranked below the filter because the same access finds both.
- The hose crushed behind the machine — High here because these machines are light and frequently moved, and the hose is what gets crushed when the cabinet is pushed back.
- The pump motor not running — Last among the mechanical causes because a blocked pump sounds like a dead one.
What to check first, second, third
- Start at the filter behind the access panel — Clean the chamber as well as the filter, and check the impeller behind it turns freely by hand.
- Pull the machine out and follow the drain hose — Check the height against the machine rather than guessing: both ends of the range cause faults.
- Turn the impeller by hand with the machine isolated — Only with the power off — it is a motor and it will run.
- Test the household drain the machine feeds — Gurgling or backing up elsewhere points at the house.
Before you open anything
Safety
Use the small emergency drain hose beside the filter where the model has one, rather than taking the cap off a full machine. Never run the machine with a panel off to watch the pump — close it up before testing. Pull the plug first, then work: water and a live machine is the hazard in this job.
Models in the CL washer family
Reference| Model number | Family key |
|---|---|
| CL09N1A** | comfee:washer:cl |
When this stops being a DIY job
Ask for the pump and the hose route to be checked together if the fault keeps coming back. The line here is the pump: a blocked path is owner work, a failed pump is a part and a fitting.
Nearest pages for this family
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
