The short answer
A Comfee CLV washer that bangs on the spin is usually reporting how it is loaded and how it stands, not a broken part. Portable models get moved between washes, which means the feet and the floor change with every use. Grinding, squealing and knocking are the sounds that point at parts and they are named below.
What you actually observe
- It can be rocked by hand — A machine that rocks by hand will move under spin.
- Banging only during the spin — A single heavy item is the usual culprit.
- The room booms with the machine — Rubber mats reduce it on hard floors and boards help on springy ones.
- Scraping that follows the drum — Coins, clips and underwires pass into the gap and grind there.
- A high-pitched sound at speed — A squeal that changes with load is belt slip rather than a bearing.
- NEAR MISS — the drum never accelerates — Most machines refuse to spin with water inside, so check the water first.
Causes, most likely first on the CLV line
- A coin or underwire grinding — Common wherever pockets go unchecked, which makes it routine rather than exotic.
- Washing gathered on one side — Top of the list also because it is the cause that recurs — it is a habit rather than a fault.
- Machine not level or rocking — Lock nuts are part of it: a foot that unwinds undoes the work.
- Play in the drum — It ranks bottom on frequency but top on cost, which is why the free causes come before it.
- The tub swinging too far — On compact machines the suspension is modest, so it wears within the life of the machine.
What to check first, second, third
- Open the door, spread the washing, spin again — Try a half load of similar items — if it is quiet, loading is the answer.
- Level the machine and lock the feet — Re-check after a spin: machines settle.
- Look for shipping restraints at the rear — A bolted tub is rigid, which is what makes the noise so violent.
- Try a mat, a board or a different position — A rubber mat on tile or a board on timber is often the whole fix.
- Feel and listen for roughness or play — A drum that feels rough or moves in and out against the shaft points at the bearing.
Before you open anything
Safety
A machine that spins with the lid up should be taken out of use, not used carefully. A machine that is walking can pull its hoses tight or unplug itself — stop it before it reaches the wall. Never put a hand in a moving drum to find a noise.
Models in the CLV washer family
Reference| Model number | Family key |
|---|---|
| CLV09N1AMG | comfee:washer:clv |
| CLV16N2A** | comfee:washer:clv |
| CLV17N2A** | comfee:washer:clv |
| CLV18N1A** | comfee:washer:clv |
| CLV20N2A** | comfee:washer:clv |
| CLV20N3A** | comfee:washer:clv |
| CLV24N2A** | comfee:washer:clv |
| CLV30N4A** | comfee:washer:clv |
When this stops being a DIY job
Ask which part was confirmed and how — that detail matters before parts are ordered. Call once the load, the level, the floor and the drum check are all clean and the noise remains.
Nearest pages for this family
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
