In short, on FLW models
On an Avanti FLW washer "will not drain" and "will not spin" are the same complaint. The control refuses to spin until the water is gone, so a blocked pump path presents as a failed spin and owners chase the wrong part. Clear the path first and the spin usually returns with it.
Signs you can observe
- The load comes out soaking rather than damp — On the FLW models listed below, soaking clothes with an empty drum means a partial blockage, not a total one.
- Water is still in the drum when the cycle ends — For FLW models, the pump path did not clear, and the machine has given up rather than spin against the water.
- It drains but very slowly — On the FLW line, slow drainage is the same fault caught early, and it is much easier to clear now.
- The drum is full and the machine has simply stopped — In the FLW family, many controls halt when the level does not fall rather than carrying on and reporting later.
- The pump hums but nothing moves — On the FLW line, hum without drainage points at a foreign object in the pump rather than at a dead motor.
- NEAR MISS — water on the floor rather than in the drum — That is a leak, and the water-leak page for your model line is the right one — leaks need attention faster.
Ranked causes on the FLW line
- A blocked pump filter or coin trap — It leads because it is the one part of the drain path the maker intends the owner to open, and because most machines that will not drain have nothing else wrong.
- A blocked pressure-sensing tube confusing the level reading — If the control believes the drum still has water it will not spin, and a silted sensing tube produces exactly that belief. That is the position it takes on this family.
- A standpipe or household waste that cannot take the flow — The machine pumps correctly and the pipe it pumps into is restricted, so the water comes back.
- A control or wiring fault at the pump circuit — Last: boards and harnesses do fail, but far less often than a filter fills. That ranking holds across the FLW line.
Work through these in order
- Open the pump filter and empty it — On the FLW models listed below, have a shallow tray and towels ready: the drum water comes out here, and there is more of it than you expect.
- Redistribute the load and try a spin alone — An out-of-balance load makes a machine abandon the spin and leave the load wet.
- Check the drain hose has a rise above the drum — Look at how the hose is clipped at the back, and whether it has been pushed flat against the wall.
- Pull the machine out and follow the drain hose by hand — On the FLW line, feel along the whole length rather than looking: a flattened section does not always show.
Safety before access
Safety
Unplug the washer before you open the filter — a capacitor can hold a charge after the power is off, and the pump can start while your fingers are in the housing. Expect water: empty the drum as far as you can first, put towels down, and work with a tray in place. Leave the door latch and the lid switch exactly as built.
Models in the FLW family
Reference| Model number | Family key |
|---|---|
| FLW22V0W | avanti:washer:flw |
When to call a technician
The owner line is the filter, the impeller you can reach through it, the hose and the household drain. Beyond that, call. A pump that is silent at the drain step, rather than humming, is the clearest signal that the fault is electrical and needs a meter.
Other FLW problems we cover
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
