Dryer motor runs but drum won't spin? We fix belts, rollers, and motors. Same-day service, 90-day warranty. Average repair cost: $100–$300. Professional service recommended.
Dryer won't tumble repair typically costs $100 to $300. This repair requires professional tools and expertise. Most repairs are completed in 1-2 hours with a free diagnostic visit.
Novato's 86°F summers and soft water at 40 TDS provide favorable conditions for dryer mechanical components. Belts achieve full 8-12 year lifespan. Drum glides last longer than in hard-water cities. Tumble failures trace to standard wear. Five providers serve the market with Marin supplementation.
Novato's warm climate and soft water preserve all dryer mechanical components. Five providers serve locally.
Broken drive belt
Failed drum rollers
Worn drum bearing
The thin flat belt wrapping around the drum snaps from age, heat exposure, and dry rot. In Bay Area garages where temperature swings between fog-cooled mornings and afternoon warmth cycle the rubber daily, belts deteriorate faster. The motor hums but the drum sits still.
Cost: $100–$180 | Time: 40-55 minutes
The spring-loaded idler pulley maintains belt tension. Its bearing seizes from lint infiltration and heat stress, causing the belt to slip off or snap. A squealing sound before the drum stopped turning is a telltale sign of idler failure.
Cost: $100–$200 | Time: 40-50 minutes
When drum rollers wear flat or seize entirely, the motor cannot overcome the friction to turn the drum. The motor may trip its thermal overload and shut off. In Bay Area homes running daily loads of heavier fabrics (blankets, comforters), roller wear is accelerated.
Cost: $130–$260 | Time: 45-70 minutes
The drive motor itself can fail from overheating caused by restricted venting or from age. The motor either does not run at all or hums without turning. Burnt smell from the motor area confirms failure. Bay Area homes with vent restrictions compound motor thermal stress.
Cost: $180–$300 | Time: 60-90 minutes
| Detail | Range |
|---|---|
| Diagnostic | Free |
| Typical repair cost | $100–$300 |
| Repair time | 1-2 hours |
| Warranty | 90 days parts + labor |
Cost varies by root cause. Exact quote after free diagnostic visit.
This repair involves electrical components or sealed systems requiring professional tools and certification.
Bay Area dryer tumble repairs average $100-$300. Novato has 5 providers. San Rafael supplements. Diagnostic fees of $89-$129 are waived with repair.
In Novato, wide day-night temperature swings (30f+ delta) stress thermal expansion joints, thermostat cycling, and sealed-system pressures. This can affect your appliance's gas valve coils: temperature swings weaken the gas valve solenoid coils over time, causing intermittent ignition failures mid-cycle (the classic "cycles fine then stops heating" symptom) If the dryer heats initially then stops, replace the gas valve coils as a set — this is the most common gas dryer repair
In Novato, very low mineral content (<60 ppm tds) or sodium-softened water causes over-sudsing, rubber swelling, and reduced detergent rinsing. This can affect your appliance's lint filter: excess detergent residue from soft-water washing coats the lint filter mesh with an invisible film, restricting airflow even when the filter appears clean Scrub the lint filter with a soft brush and warm soapy water monthly; hold it under running water — if water pools, the filter is coated
Free diagnostic visit for won't tumble issues. Same-day appointments available in Novato.
Book Free DiagnosticReviewed by Marcus Rivera, Senior Refrigeration & HVAC Technician
Seized idler pulley
Motor failure
$80–$250 avg