Verified
“Gas dryer wouldn't ignite. Flame sensor and gas valve solenoids replaced. Runs hot again. Tech explained everything clearly.”
Mark S.
Dryer Repair
Dryer motor runs but drum won't spin? We fix belts, rollers, and motors. Same-day service, 90-day warranty. Average repair cost: $100–$300. Professional service recommended.
LG dryer was taking three cycles to dry a single load in Walnut Creek. Turned out the vent was 80% blocked with lint — technician cleared the full run and replaced the moisture sensor. Dries in one cycle now.
“Gas dryer wouldn't ignite. Flame sensor and gas valve solenoids replaced. Runs hot again. Tech explained everything clearly.”
“Gas dryer wouldn't ignite. Flame sensor and gas valve solenoids replaced. Runs hot again. Tech explained everything clearly.”
“Dryer made a loud squealing noise. Drum rollers and belt were worn. Tech had both parts and finished in 45 minutes.”
“Dryer made a loud squealing noise. Drum rollers and belt were worn. Tech had both parts and finished in 45 minutes.”
“Dryer was taking 3 cycles to dry a single load. Turned out the vent was clogged and the heating element was partially burned out. Both fixed in one visit.”
Dryer won't tumble repair typically costs $100 to $300. This repair requires professional tools and expertise. Most repairs are completed in 1-2 hours with a free diagnostic visit.
Broken drive belt
Failed drum rollers
Worn drum bearing
Seized idler pulley
Motor failure
The thin flat belt wrapping around the drum snaps from age, heat exposure, and dry rot. In Bay Area garages where temperature swings between fog-cooled mornings and afternoon warmth cycle the rubber daily, belts deteriorate faster. The motor hums but the drum sits still.
Cost: $100–$180 | Time: 40-55 minutes
The spring-loaded idler pulley maintains belt tension. Its bearing seizes from lint infiltration and heat stress, causing the belt to slip off or snap. A squealing sound before the drum stopped turning is a telltale sign of idler failure.
Cost: $100–$200 | Time: 40-50 minutes
When drum rollers wear flat or seize entirely, the motor cannot overcome the friction to turn the drum. The motor may trip its thermal overload and shut off. In Bay Area homes running daily loads of heavier fabrics (blankets, comforters), roller wear is accelerated.
Cost: $130–$260 | Time: 45-70 minutes
The drive motor itself can fail from overheating caused by restricted venting or from age. The motor either does not run at all or hums without turning. Burnt smell from the motor area confirms failure. Bay Area homes with vent restrictions compound motor thermal stress.
Cost: $180–$300 | Time: 60-90 minutes
| Detail | Range |
|---|---|
| Diagnostic | Free |
| Typical repair cost | $100–$300 |
| Repair time | 1-2 hours |
| Warranty | 90 days parts + labor |
Cost varies by root cause. Exact quote after free diagnostic visit.
This repair involves electrical components or sealed systems requiring professional tools and certification.
Free diagnostic visit for won't tumble issues. Same-day appointments available in Bay Area.
Book Free DiagnosticReviewed by Marcus Rivera, Senior Refrigeration & HVAC Technician
Samsung dryer kept shutting off after ten minutes in San Mateo. Technician found the thermal fuse had blown due to a clogged exhaust vent. Replaced the fuse and cleared the vent — works perfectly now.
Whirlpool gas dryer was producing no heat at all in our Hayward apartment. Tech found the gas valve solenoid had failed and replaced it on the first visit. Clothes come out warm and dry in one cycle.
Verified reviews from homeowners across San Francisco and Bay Area
“Sub-Zero 36-inch built-in with a noisy compressor. Compressor mounts were worn causing vibration. Mounts replaced and compressor serviced for $295. Fridge is quiet and cooling perfectly. Sub-Zero expertise is rare and valuable.”
Tammy B.
Refrigerator Repair
Palo Alto, CA
“Our Samsung dishwasher was leaking from the bottom. The technician found a loose hose clamp on the circulation pump. It was a simple fix for $120 — I really appreciated the honesty since they could have sold me a new pump. The dishwasher has been leak-free since. Trustworthy company.”
Yuki N.
Dishwasher Repair
San Mateo, CA
“KitchenAid built-in refrigerator was forming puddles underneath. Clogged defrost drain was sending water out the bottom instead of into the drain pan. The tech cleared the drain, added a drain heater clip to prevent recurrence, and cleaned the drain pan. $175 for a fix that eliminated a really annoying problem.”
Alicia R.
Refrigerator Repair
Palo Alto, CA
“Our LG French door refrigerator stopped cooling overnight. With a fridge full of food, we needed emergency service. The tech came same-day, diagnosed a failed compressor relay, and had it running in under an hour. He also told us about LG's compressor warranty which covered the part. Outstanding service.”
Anthony R.
Refrigerator Repair
Sunnyvale, CA
“Our 20-year-old Sub-Zero had a warm refrigerator section. The tech was clearly experienced with Sub-Zero — he diagnosed a failing evaporator fan and weak door gaskets. Replaced both, cleaned the condenser, and the unit is performing like new. $520 for a repair on a unit worth $15K+ to replace. No-brainer.”
Richard Y.
Refrigerator Repair
Cupertino, CA
“Called EasyBear on a Sunday morning when my Samsung fridge stopped cooling. A technician arrived by early afternoon, diagnosed a failed evaporator fan motor, and had it replaced within 90 minutes. Food saved, stress gone. The $265 was absolutely worth it.”
Karen L.
Refrigerator Repair
San Francisco, CA
“Whirlpool fridge compressor running non-stop. Dirty condenser coils were the culprit. Thorough cleaning for $95 service fee. Compressor now cycles normally and energy bill dropped.”
Dave K.
Refrigerator Repair
Daly City, CA
“The technician arrived within 2 hours of my call and diagnosed the issue immediately — a faulty defrost timer causing ice buildup. He had the part on his truck and fixed it in under an hour. My fridge has been running perfectly for 3 months now. Very reasonable price at $275.”
Sarah M.
Refrigerator Repair
San Francisco, CA
“GE upright freezer was running but not getting below 25°F. The evaporator fan motor was failing. Tech replaced it and also checked the defrost system which was still working fine. $210 total and the freezer is back to 0°F. Saved about $800 in frozen food that would have spoiled. Worth every penny.”
Raymond G.
Freezer Repair
San Francisco, CA
“Our chest freezer stopped freezing and we had hundreds of dollars of meat inside. Called at 8am and the tech arrived by 10:30am. Faulty thermostat was the culprit — replaced in 30 minutes. Saved all our food! Cost was $175. Can't thank them enough for the fast response.”
Amanda J.
Freezer Repair
Concord, CA
“Finding someone experienced with Sub-Zero was tough until I found this company. Our 15-year-old Sub-Zero was running constantly and not cooling. The tech cleaned the condenser, replaced the fan motor, and it's been running like new. Worth every penny of the $450 repair — a new Sub-Zero is $12,000+.”
James C.
Refrigerator Repair
Berkeley, CA
“The notorious Samsung ice maker problem struck our French door fridge. The tech was very familiar with this specific issue, performed the recommended fix including defrosting the evaporator and installing a new ice maker kit. It's been 6 weeks and still working great. $350 well spent.”
Wei Z.
Refrigerator Repair
Cupertino, CA