Dryer motor runs but drum won't spin? We fix belts, rollers, and motors. Same-day service, 90-day warranty. Average repair cost: $100–$300. Professional service recommended.
Dryer won't tumble repair typically costs $100 to $300. This repair requires professional tools and expertise. Most repairs are completed in 1-2 hours with a free diagnostic visit.
Sausalito's persistent fog creates the most challenging conditions in Marin for dryer mechanical components. Constant humidity degrades belt rubber in 5-7 years. Hillside cottage installations add access complexity. Salt-air proximity corrodes roller bearings. Very soft water at 35 TDS is favorable for glides. Two providers serve the small market.
Sausalito's extreme fog shortens belt life to 5-7 years and corrodes bearings. Hillside cottages add access complexity. Very soft water is favorable. Two providers serve locally.
Broken drive belt
Failed drum rollers
Worn drum bearing
The thin flat belt wrapping around the drum snaps from age, heat exposure, and dry rot. In Bay Area garages where temperature swings between fog-cooled mornings and afternoon warmth cycle the rubber daily, belts deteriorate faster. The motor hums but the drum sits still.
Cost: $100–$180 | Time: 40-55 minutes
The spring-loaded idler pulley maintains belt tension. Its bearing seizes from lint infiltration and heat stress, causing the belt to slip off or snap. A squealing sound before the drum stopped turning is a telltale sign of idler failure.
Cost: $100–$200 | Time: 40-50 minutes
When drum rollers wear flat or seize entirely, the motor cannot overcome the friction to turn the drum. The motor may trip its thermal overload and shut off. In Bay Area homes running daily loads of heavier fabrics (blankets, comforters), roller wear is accelerated.
Cost: $130–$260 | Time: 45-70 minutes
The drive motor itself can fail from overheating caused by restricted venting or from age. The motor either does not run at all or hums without turning. Burnt smell from the motor area confirms failure. Bay Area homes with vent restrictions compound motor thermal stress.
Cost: $180–$300 | Time: 60-90 minutes
| Detail | Range |
|---|---|
| Diagnostic | Free |
| Typical repair cost | $100–$300 |
| Repair time | 1-2 hours |
| Warranty | 90 days parts + labor |
Cost varies by root cause. Exact quote after free diagnostic visit.
This repair involves electrical components or sealed systems requiring professional tools and certification.
Bay Area dryer tumble repairs average $100-$300. Sausalito has 2 providers. San Rafael and San Francisco supplement. Hillside cottage access may add $25-$50 to labor. Diagnostic fees of $89-$129 are standard.
In Sausalito, salt-laden marine air and persistent fog deposit corrosive moisture on metal surfaces and electronics. This can affect your appliance's exhaust vent flapper: salt corrosion seizes the exterior vent flapper, trapping lint-laden humid air and increasing fire risk Inspect and lubricate the exterior vent flapper every 6 months; replace plastic flappers with stainless steel
In Sausalito, sustained relative humidity above 60% promotes mold growth, condensation on cold surfaces, and accelerated corrosion. This can affect your appliance's exhaust duct: humid air entering through the exhaust when the dryer is off creates condensation inside the duct, trapping lint into a paste that restricts airflow Install a quality exterior vent cover with a tight-closing flapper; clean the full duct run annually
In Sausalito, very low mineral content (<60 ppm tds) or sodium-softened water causes over-sudsing, rubber swelling, and reduced detergent rinsing. This can affect your appliance's lint filter: excess detergent residue from soft-water washing coats the lint filter mesh with an invisible film, restricting airflow even when the filter appears clean Scrub the lint filter with a soft brush and warm soapy water monthly; hold it under running water — if water pools, the filter is coated
Free diagnostic visit for won't tumble issues. Same-day appointments available in Sausalito.
Book Free DiagnosticReviewed by Sarah Chen, Appliance Diagnostics Engineer
Seized idler pulley
Motor failure
$80–$250 avg