Dryer motor runs but drum won't spin? We fix belts, rollers, and motors. Same-day service, 90-day warranty. Average repair cost: $100–$300. Professional service recommended.
Dryer won't tumble repair typically costs $100 to $300. This repair requires professional tools and expertise. Most repairs are completed in 1-2 hours with a free diagnostic visit.
Loomis dryer tumble failures are uncommon thanks to soft water and cooler temperatures. When they occur, normal belt aging is the typical cause. Rural horse property installations may face rodent damage to belts. Power fluctuations from the rural electrical grid may contribute to motor issues.
Loomis excellent conditions mean dryer belts last as long as anywhere in the metro. Rural property installations may face unique factors like rodent damage. The small community size may affect scheduling.
Broken drive belt
Failed drum rollers
Worn drum bearing
The flat rubber belt wrapping the drum cracks and snaps from dry rot. Sacramento garages with daily temperature swings (cool morning to 110+ afternoon) cycle the rubber through expansion and contraction, creating micro-cracks that propagate until the belt snaps. Motor hums but drum is still.
Cost: $100–$180 | Time: 40-55 minutes
The idler pulley bearing seizes from lint infiltration and heat. In Sacramento conditions, bearing grease thins from high ambient temperature and migrates out of the bearing, leaving it dry. The pulley locks up, and the belt either snaps or slips off the pulley entirely.
Cost: $100–$200 | Time: 40-50 minutes
Drum rollers that are severely worn can seize, creating too much resistance for the motor to overcome. The motor tries to turn but stalls and trips its thermal overload. Sacramento heat softens roller rubber during the day, and weight deformation hardens when cool — eventually the flat spot seizes.
Cost: $130–$260 | Time: 45-70 minutes
Drive motors fail from overheating when combined with Sacramento ambient heat and vent restrictions. The motor either will not run at all (winding open) or hums but cannot overcome starting torque (failed start capacitor or seized bearing). Burnt smell confirms motor failure.
Cost: $180–$300 | Time: 60-90 minutes
| Detail | Range |
|---|---|
| Diagnostic | Free |
| Typical repair cost | $100–$300 |
| Repair time | 1-2 hours |
| Warranty | 90 days parts + labor |
Cost varies by root cause. Exact quote after free diagnostic visit.
This repair involves electrical components or sealed systems requiring professional tools and certification.
Dryer tumble failure repairs in the Sacramento metro typically run $100 to $300. In Loomis, belt replacement at $100 to $175 plus a possible trip charge is typically sufficient.
In Loomis, sustained high temperatures with low humidity cause thermal stress on mechanical components and accelerate rubber degradation. This can affect your appliance's thermal fuse: already-high ambient temperatures reduce the thermal margin, causing premature thermal fuse trips even with clean vents Clean the full vent run annually; ensure the dryer is not in an enclosed space without airflow
In Loomis, wide day-night temperature swings (30f+ delta) stress thermal expansion joints, thermostat cycling, and sealed-system pressures. This can affect your appliance's gas valve coils: temperature swings weaken the gas valve solenoid coils over time, causing intermittent ignition failures mid-cycle (the classic "cycles fine then stops heating" symptom) If the dryer heats initially then stops, replace the gas valve coils as a set — this is the most common gas dryer repair
Free diagnostic visit for won't tumble issues. Same-day appointments available in Loomis.
Book Free DiagnosticReviewed by Robert Aguilar, Field Service Manager & Technical Reviewer
Seized idler pulley
Motor failure
$80–$250 avg