Dryer running but not heating? We fix heating elements, thermal fuses, and igniters. Same-day service, 90-day warranty. Average repair cost: $100–$350. Professional service recommended.
Dryer not heating repair typically costs $100 to $350. This repair requires professional tools and expertise. Most repairs are completed in 1-2 hours with a free diagnostic visit.
Loomis dryers enjoy one of the more favorable environments in the Sacramento metro area, with foothill transitional climate delivering summer peaks of only 94 to 100 degrees and good evening cool-down. Placer County Water Agency surface water is relatively soft and high quality, minimizing the mineral-lint vent buildup that plagues harder-water communities. However, the rural-suburban character of Loomis introduces unique challenges. Homes on one to five acre parcels along Brace Road and Taylor Road often house laundry equipment in detached workshops, horse barn utility rooms, or detached garages with longer-than-standard vent runs. These structures may have dedicated appliance circuits that were installed decades ago and are undersized for modern high-draw dryers. Custom-built homes from the 1970s to 2000s have varied layouts with non-standard vent routing that can be difficult to clean and inspect. The rural property character means tree debris, including pine needles and oak leaves, accumulates near outdoor vent terminations. Occasional winter frost in this foothill zone can affect vent connections in unheated outbuildings.
Loomis's moderate foothill climate and soft Placer County water are genuinely gentler on dryer heating components than valley floor conditions. However, the rural-suburban property character creates challenges through longer vent runs in detached buildings, potentially undersized electrical circuits in workshops and outbuildings, and agricultural debris from horse properties. Winter frost can affect unheated vent runs in ways that valley floor homes never experience.
Burned out heating element
Blown thermal fuse
Faulty gas igniter
Failed thermostat
Restricted vent
Electric dryer heating coils break from thermal stress over time. Sacramento families running 10+ loads per week (common in Elk Grove, Roseville, and Folsom households with children and active lifestyles) cycle heating elements through more on/off cycles annually, reducing lifespan to 5-7 years.
Cost: $130–$250 | Time: 45-60 minutes
Despite shorter vent runs in Sacramento homes, lint buildup still triggers thermal fuse failures — especially in homes where dryer sheets are used heavily (creating waxy lint trap residue) and in households that rarely clean the lint trap between every load.
Cost: $100–$170 | Time: 30-45 minutes
Gas dryers common in older Sacramento neighborhoods (Land Park, Curtis Park, East Sacramento) use dual solenoids that weaken with age. The dryer starts hot but loses heat mid-cycle as weakened solenoids cannot hold the gas valve open for extended periods.
Cost: $130–$230 | Time: 45-60 minutes
The safety thermostat that monitors exhaust temperature trips prematurely when covered in lint or when Sacramento summer heat elevates garage/laundry room ambient temperatures above normal. Garages reaching 120°F reduce the thermal margin these devices have before tripping.
Cost: $110–$200 | Time: 30-45 minutes
| Detail | Range |
|---|---|
| Diagnostic | Free |
| Typical repair cost | $100–$350 |
| Repair time | 1-2 hours |
| Warranty | 90 days parts + labor |
Cost varies by root cause. Exact quote after free diagnostic visit.
This repair involves electrical components or sealed systems requiring professional tools and certification.
Dryer heating repairs in the Sacramento metro typically run $100 to $350. In Loomis, the favorable climate and water quality mean dryers need fewer heating repairs over their lifetime. When repairs are needed, the rural property layout may add complexity if the dryer is in a detached building with non-standard electrical or vent routing, potentially costing $175 to $300.
In Loomis, sustained high temperatures with low humidity cause thermal stress on mechanical components and accelerate rubber degradation. This can affect your appliance's thermal fuse: already-high ambient temperatures reduce the thermal margin, causing premature thermal fuse trips even with clean vents Clean the full vent run annually; ensure the dryer is not in an enclosed space without airflow
In Loomis, wide day-night temperature swings (30f+ delta) stress thermal expansion joints, thermostat cycling, and sealed-system pressures. This can affect your appliance's gas valve coils: temperature swings weaken the gas valve solenoid coils over time, causing intermittent ignition failures mid-cycle (the classic "cycles fine then stops heating" symptom) If the dryer heats initially then stops, replace the gas valve coils as a set — this is the most common gas dryer repair
Free diagnostic visit for not heating issues. Same-day appointments available in Loomis.
Book Free DiagnosticReviewed by Robert Aguilar, Field Service Manager & Technical Reviewer