Expert advice, troubleshooting guides, and maintenance tips for all your appliances
5,493 articles
Or call (415) 795-7300

A systematic way to diagnose a GE dishwasher across GDT and GDP models: find the tech sheet, read error codes, run diagnostic mode, then work symptom by symptom.

US GE dishwashers have no salt container; spotty dishes trace to the rinse aid dispenser. Covers filling, dosage adjustment, replacing the cap seal, and swapping the assembly.

Fix an older GE dishwasher that will not drain by replacing the drain solenoid valve. Covers confirming the reversing-motor design, testing the coil, and reconnecting the plunger.

Swap an old dishwasher for a new GE unit in the same cutout: remove the old one, wire the junction box, plumb the supply and drain, level, and leak-check the first run.

Confirm whether a GE dishwasher control board is truly at fault before replacing it, using SmartHQ, service mode, and careful multimeter checks of input voltage, relays, and sensors.

Fix a GE dishwasher that will not fill, fills slowly, or bangs with water hammer by replacing the WD15X10003 inlet valve. Covers confirming the valve, then a clean swap under the tub.

Complete guide to deep cleaning your GE dishwasher including the two-part filter, Piranha hard food disposer, spray arms, and tub interior. Learn about...

Step-by-step guide to replacing the water inlet valve on Frigidaire EFLS front-load and FFTW top-load washers. Covers E11 fill error diagnosis.

Guide to replacing tub suspension springs on Frigidaire EFLS front-load washers. Covers excessive vibration diagnosis, spring access via top panel.

Replace the sump-mounted heating element on your GE dishwasher when dishes are not drying or water is not reaching temperature. Complete DIY guide.

Diagnose and replace the main control board on a Frigidaire front-load washer. Covers when it is really the board, connector photos, and a pre-close test.

Replace the thermistor or turbidity sensor on a GE dishwasher when cycles run long, water will not heat, or a C3 code appears. Covers resistance testing and sump access.

Step-by-step guide to safely disconnecting and removing a Frigidaire front-load (EFLS) or top-load (FFTW) washing machine. Covers water supply shutoff.

Step-by-step guide to replacing the door lock assembly (part 137353500) on Frigidaire EFLS front-load washers. Covers E41 error diagnosis and lock access.

Step-by-step guide to replacing the drive belt (part 137315300) on Frigidaire front-load EFLS washers. Covers the spring-loaded tensioner and belt routing.

An E35 overfill or E11 underfill on a Frigidaire washer means a bad water-level pressure switch or a kinked air tube. Check the tube, blow-test the switch, and swap it.

Trace why a GE dishwasher is dead or tripping breakers: circuit breaker, junction box, door interlock, thermal fuse, and component winding tests with resistance values.

Replace the drive motor on a Frigidaire EFLS front-load washer after an E52 error, burning smell, or no-spin. Covers winding tests, belt and tachometer removal, and transferring the mount.

Fix a Frigidaire FFTW top-load washer that agitates but won't spin by replacing the lid switch. Covers the agitate-no-spin diagnosis, console-cap access, plunger testing, and striker alignment.

Replace a cracked filter cap, worn gasket, or split filter housing on a Frigidaire front-load EFLS washer. Step-by-step housing swap, hose reconnection, and leak verification to clear the E21 error.

Fix a Frigidaire FFTW top-load washer that spins weakly from a worn, glazed drive pulley. Covers pulley diagnosis, cabinet removal, belt and pulley removal from the transmission shaft, and testing.

Replace all four shock absorbers (part 5304485917) on a Frigidaire front-load washer through the rear panel. Covers the pin-and-socket mounts, seating checks, and a spin test.

Soaked laundry comes out of a washer that could not drain and out of one that drained and never spun — different repairs entirely. What is left in the tub at the end sorts them before the filter door is even opened.

Trace excessive vibration on a Frigidaire EFLS front-load or FFTW top-load washer: shipping bolts, leveling, load balance, shock absorbers, suspension springs, rods, and counterweights.
A component-by-component repair reference for Frigidaire EFLS and FFTW washers: drain pump, door lock, drive belt, shock absorbers, bearings, and inlet valve, with part numbers.
Replace a failed GE dishwasher drain pump (WD26X10039 or WD26X23258) when water stands in the tub: confirm the failure, bail the sump, twist out the pump, and test.
Fix a GE dishwasher that leaves dishes wet: identify heated, fan, or condensation drying, then test the heater (10-20 ohms), vent fan, actuator, and rinse aid on Profile and Cafe models.

Intermediate 30-45 minute guide to replacing worn motor carbon brushes on an older Frigidaire top-load washer: confirming your motor has brushes, inspecting the commutator, and bedding in the new set.

A Frigidaire top-loader that hums but will not agitate or spin usually has a sheared motor coupling — a cheap sacrificial part. Here is the tilt-back replacement.
A microwave capacitor holds 2,000-5,000 volts after it is unplugged, which splits every symptom into two piles. A table of which faults are a two-minute fix and which are strictly a technician job.
Let our professional technicians help. Same-day service available.