The short answer
3d41 on a Maytag oven is the control reporting a fault in the unclassified control fault. The code table records the documented meaning, and the causes below it are ordered by how often each one is the answer. Carry on using it and write down when the code comes back.
The documented code and its meaning
Reference| Code | Meaning |
|---|---|
| 3d41 | Location may vary. |
What you actually observe
- It appears at a different point in the cycle each time — No pattern is itself a finding.
- The code appeared once and nothing else seems wrong — The most common version, and the one that needs nothing.
- Another, more specific code has appeared since — The specific code is the one to work from.
- NEAR MISS — the appliance has stopped working entirely — Then something else has failed and this code is not the story.
Causes, most likely first on this oven
- A transient the control could not attribute to any specific part — That is what this code means: the control knows something went wrong and cannot say what.
- A supply disturbance during a cycle — A dip or a spike is the commonest trigger for a fault the control cannot name.
- An intermittent connection somewhere in the harness — A fault that appears and clears before the control can identify it usually is not a failed part yet.
- An early sign of a component about to fail properly — Occasionally this code is the warning that a nameable fault is on its way.
Check in this order, and why
- Power down completely and see whether the code returns — An unnamed fault that never comes back was a transient and needs nothing.
- Set down what was running each time it appears — The pattern, and not the code, is what identifies this one.
- Note anything else in the house that lost power at the same moment — A shared event points at the supply rather than the appliance.
- Wait for a second, nameable code before buying parts — Buying a board against an unnamed fault is the commonest way money is wasted here.
What an owner can safely check
- Take the breaker off for a full minute and restore it — This is the whole of the owner-side response to a code the control cannot name.
About 3 min
- Keep a short log of when the code appears and what was selected — Three dated entries are worth more than any description of the code itself.
Tools: pen and paperAbout 5 min
- Carry on using it normally unless something else goes wrong — A single unattributed event is not a reason to stop using the appliance.
Before anything is opened
Safety
Before any panel comes off, unplug the appliance or switch off its breaker: a capacitor can hold a charge after the power is off. A built-in oven is normally hard-wired, so the breaker is the isolation point rather than a plug. The cavity and the door glass stay hot for a long time after a bake cycle ends. The switches on the door are there to cut power at a particular moment. Leave their wiring as it was found.
When this stops being an owner job
Arrange a visit if the code appears repeatedly, or a second, more specific code joins it. From there on it is a meter on a de-energised circuit, and reaching the rear of a built-in oven means unseating it from the cabinetry first. Call sooner than that if you smell burning, see scorching around the control area, or the appliance trips the breaker when it starts — any one of those is a stop-now signal rather than a wait-and-see one.
Nearest error-code pages
What this page does not cover
Treat this as the family-agnostic reading of 3d41 for Maytag oven models on the common control platform. What it is not: a reading for an older control generation that shows the same characters for something else, and not a source for wiring colours, pin numbers, torque values or part numbers. Those differ family by family. A family or model page, where one exists, is the more specific answer and should be followed instead; the index linked below is where they are collected.
Other Maytag oven codes
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
