The short answer
Noise from a Euhomy machine is identified by character rather than by volume: a rhythmic thump is usually a drum roller or a flat spot, a squeal is a glide or an idler, a scrape is the drum touching the bulkhead, and a rattle is something loose in the blower. Because this badge sells online with no dealer network behind it, check the feet and the load for coins and zips before anything comes apart.
How the fault presents
- A low rumble that worsens steadily over weeks — Drum support wear, which ends in a scraped drum if it is left.
- Thumping only with a heavy load — Normal tumbling noise amplified by weight, and sometimes just the load hitting the drum.
- A metallic scrape that changes when you press the door — The drum is running against the bulkhead or the front seal has worn away.
- NEAR MISS: the ordinary thumping of a heavy wet load tumbling — Loads hitting the drum are normal.
Causes, most likely first
- Feet, levelling or contact with a neighbouring machine — First, and by a clear margin: a dryer stacked on, or jammed against, a washer transmits every vibration into the other cabinet and into the floor.
- Drum rollers, glides or bearings worn — Second: on many platforms they are the defined wear part and they are replaced as a set, which is the normal mid-life dryer repair.
- An object loose in the drum, the blower or the lint path — Third: coins, buttons, pen caps and underwire pass the drum seal and end up in the blower, where they rattle at speed and eventually break the wheel.
Check in this order
- Rock each corner by hand and check all four feet — Any movement is a levelling fault and it is free to correct.
- Turn the empty drum slowly by hand and listen — Roughness, a catch once per turn, or a groan all point at the drum supports.
- Run the machine empty for a minute and listen for rattles — A rattle that tracks the blower rather than the drum is an object in the housing.
Owner-side checks, step by step
- Check pockets and the drum seal lip for coins and wires — Run a finger round the seal gap with the power off.
Tools: torchAbout 10 min
- Turn the empty drum slowly by hand, listening — Roughness or a catch once per turn points at rollers or bearings.
About 10 min
- Look for grey marking on light-coloured clothes — Marking plus scraping means a worn seal and a dropped drum.
About 5 min
- STOP HERE for anything inside the cabinet — Rollers, belts, seals and blower wheels all need the machine opened, the drum out on many platforms, and the supply isolated.
Safety before diagnosis
Safety
A scraping drum can mark and eventually tear clothing, and a rattling blower breaks up and sends debris into the duct: neither is worth running for months. Unplug the appliance or switch off its breaker before removing any panel, because a capacitor can hold a charge after the power is off. Never reach into a drum that is still turning. allowlist:unplug-before-service
When this becomes a service call
Emptying, levelling and finding coins are owner work. Everything in the drum support and belt path is not. The useful handover is the character of the noise and whether drying has changed, because noise plus poor drying moves the suspicion to the blower.
Other faults on this machine
What this page does not cover
Scope: the Euhomy machine as a type, diagnosed with the power off and the cabinet closed. It is not the service sheet for your build, and it lists no per-model codes, capacities or part numbers. Anything needing the rating plate in hand belongs on a named-model page, linked here when one exists.
Links: - [EUHOMY Dryer: Door, Latch or Seal Fault](/blog/euhomy-dryer-door-seal) - [Maytag Dryer: Not Heating](/blog/maytag-dryer-heating-failure)
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
