What this means on these models
A Comfee CDC dishwasher that will not start splits into two cases, and the split takes one glance. If the breaker is on and the machine is still dead, the fault is in the machine. A control lock, a delayed start, or a cycle that has not been confirmed with the start button all present identically.
What the owner sees and hears
- No lights at all — Check the breaker first, and look for a wall switch beside the sink.
- A code where the time should be — Note it exactly as it appears — it narrows the fault immediately.
- The catch does not hold — Check the strike for debris and that nothing in the top rack is protruding.
- It says it will start later — Easy to set by accident on a small panel.
- It beeps and does nothing — Push the door until the latch clicks home; a door that looks shut is not always latched.
- NEAR MISS — a full cycle with dirty plates — That is a cleaning complaint, not a start fault — a different page.
Ranked causes for these models
- Control lock armed — It ranks here because the indicator is small and easy to miss and the fix is a held button.
- Delayed start set — It belongs here because a delayed start leaves the machine lit and idle until its time arrives.
- The catch not confirming — The machine will not begin until the latch confirms, and looking closed is not the same as latched.
- Supply interrupted — It ranks top because the breaker and the switch are both free to look at.
- A stale state after a power cut — It ranks here because switching off at the breaker or spur for a minute resolves it or rules it out.
The order to work in
- Check the catch — Looking closed is not the same as latched, and the machine will not begin without it.
- Note whether the panel lights at all — Everything below follows from this.
- Prove the supply — A switched spur under the counter gets knocked during cleaning.
- Look for a control lock indicator and clear it — Armed by accident constantly, a held button does it.
- Choose a basic programme — A delay leaves the machine lit and idle until its time arrives.
What to do before the panel comes off
Safety
Switch the machine off at the breaker or spur before bailing standing water. Do not force the door or the latch — that turns a cleaning job into a part replacement. Do not reset repeatedly to see what happens — resetting is not a diagnosis.
Models in the CDC dishwasher family
Reference| Model number | Family key |
|---|---|
| CDC17P0A** | comfee:dishwasher:cdc |
| CDC17P0ABB | comfee:dishwasher:cdc |
| CDC17P0AWB | comfee:dishwasher:cdc |
| CDC17P0AWW | comfee:dishwasher:cdc |
| CDC17P2A** | comfee:dishwasher:cdc |
| CDC17P2AWW | comfee:dishwasher:cdc |
| CDC22P**** | comfee:dishwasher:cdc |
| CDC22P1*** | comfee:dishwasher:cdc |
| CDC22P1A** | comfee:dishwasher:cdc |
| CDC22P1BBB | comfee:dishwasher:cdc |
| CDC22P1BWB | comfee:dishwasher:cdc |
| CDC22P2A** | comfee:dishwasher:cdc |
| CDC22P2AWW | comfee:dishwasher:cdc |
| CDC22P4A** | comfee:dishwasher:cdc |
| CDC22P4AWW | comfee:dishwasher:cdc |
Where the owner side ends
Try a power cycle first: one minute off is worth doing. Say what you tested — it saves repeating it.
The rest of this family
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
