What this code means, briefly
Read E24 as this: the control reports an electronics fault, and the published table names no component for it. If the dryer completes a full cycle after a power cycle you can use it; stop if the code returns mid-cycle. You can settle whether this is a one-off or a real fault yourself; naming the failed part is not owner work.
Error codes
Reference| Code | Meaning |
|---|---|
| E24 | There is an electronics fault/error. |
What you actually observe
- The code appears at power-up before a programme is chosen — That is the control finding the fault during its own start-up check.
- The programme ends early with the load still damp — A control that stops rather than continues leaves the work unfinished, which is how this usually presents.
- NEAR MISS — no display and no response at all — That is a supply fault rather than an electronics code, and it starts at the breaker.
What triggers E24, most likely first
- Heat and lint dust around the control — It goes first among the causes you can act on: a dryer control sits in a warm cabinet full of fine dust, and dust bridging a connector produces an unaccountable reading that comes and goes with how hard the machine is worked.
- A genuinely failed control board — Last, and deliberately so: it is the most expensive answer, and the four causes above imitate it exactly while costing nothing to eliminate.
What to check first, second, third
- Clear the filter and the air paths before judging anything — A machine running hot because of restricted airflow is harder on its control than one that is not.
- Run one load with nothing else on the circuit — That separates a supply-sensitive reading from a live control fault.
- Cut power at the breaker for a full minute and restore it — This is the first and most informative step: stored and live faults behave differently from here on.
- Body: Eliminate the environment before the electronics — supply quality, heat and moisture cause more of these codes than boards do.
What an owner can safely do
- Switch the appliance off at the breaker for a full minute — A full minute so the control loses its supply completely, then restore power and watch the power-up.
About 5 min
- Power down for a full minute, clean the filter and air paths, then run one complete cycle and note the result — Whether it finishes, where it stops and what the display shows are the three things worth recording.
Tools: vacuum, soft brushAbout 60 min
- Run one ordinary cycle and note exactly what happens — Whether it completes, where it stops and what the display does are the three things worth writing down.
About 60 min
- STOP HERE — do not keep resetting a code that returns at once — A code that comes straight back is live, and resetting round it removes the evidence a technician needs.
Safety first
Safety
Unplug the dryer or switch off its breaker before any panel comes off — a capacitor can hold a charge after the power is off. Never run it with the filter out or the air paths blocked, because lint is combustible. On a gas model, if you smell gas, leave the building and call the gas utility from outside without switching anything on or off.
When to call a technician
Call straight away if you smell hot plastic, see scorching at a connector, or the appliance behaves unpredictably rather than simply stopping.
Nearby codes on the same appliance
Scope of this reading
What is written here is generalized to the Bosch dryer line rather than to a single family. Deliberately absent: connector positions, wiring colours, part numbers and the service sequences for your particular build, all of which vary across the line and belong in the manual for your model. If a model-specific page for this code has been published it is linked from the index below, and that page outranks this one for your unit.
Links: - [Bosch dryer error codes](/blog/bosch-dryer-error-codes)
The code index
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
