E12 at a glance
E12 on a Bosch dryer indicates overheating due to restricted airflow. Warm, moist air is not leaving the dryer quickly enough, so the temperature inside rises and the dryer protects itself. Stop the programme, let the dryer cool, and check the filter and, on a vented dryer, the duct to the outside. Restricted airflow is also a fire risk, so do not keep restarting the dryer until the cause is found.
Error codes
Reference| Code | Meaning |
|---|---|
| E12 | The E12 error code on your dryer indicates overheating due to restricted airflow. |
What happens with E12
- The dryer stops before the clothes are dry — Protection cuts the heat once the temperature climbs too high.
- The outside of the dryer feels unusually hot — Heat is staying inside the cabinet instead of being carried away.
- The laundry room gets warm and humid — Air may be escaping from a loose or damaged duct.
- Weak airflow at the outside vent — On a vented dryer, little or no air comes out of the hood on the wall.
What restricts the airflow, most likely first
- A blocked lint filter — First: the simplest restriction and the most common one.
- A crushed or kinked vent duct — Second, on vented dryers: pushing the dryer back against the wall can flatten the duct.
- Lint inside the duct or the outside hood — Third: lint collects along the duct and at the outside flap over time.
- Lint inside the dryer's airway — Fourth: fluff that has got past the filter builds up inside the cabinet.
Checks, cheapest first
- Clean the filter — Empty and, if needed, wash the lint filter.
- Look behind the dryer — Check that the duct is not crushed, kinked or disconnected.
- Check the outside hood — With the dryer running, feel for a strong flow of air at the outside vent.
- Let it cool and run a short load — If E12 returns with a clear filter and duct, the restriction is inside.
Owner steps for E12
- Stop the dryer and let it cool — Remove the load and leave the door open.
About 30 min
- Clean the lint filter — Remove all fluff and rinse the mesh if it is clogged.
Tools: soft brushAbout 10 min
- Straighten the duct — Unplug the dryer, pull it forward carefully and reshape any crushed section. Get a second person before you pull the cabinet out or tilt it.
About 15 min
- Clear the outside hood — Remove lint from the flap and make sure it opens freely.
Tools: glovesAbout 10 min
- Stop short of opening the dryer — Internal lint and sensors are dealt with by a professional with the panels off.
Tools: ::
Fire and electrical safety
Overheating with lint present is how dryer fires start, so do not leave a dryer showing E12 running unattended. Unplug it before moving it or touching the duct, and take care with its weight. Get a second person before you pull the cabinet out or tilt it. If your dryer is gas-fired, move it gently to avoid straining the gas connection, and if you smell gas, leave without switching anything on or off and call the gas utility or 911 from outside. Leave the cabinet closed, because the electronics can hold a charge.
When E12 needs a professional
Get professional help if E12 returns after the filter, duct and outside hood are clear, if the cabinet is very hot, or if there is a scorched smell. A professional clears lint from inside the dryer and checks the temperature sensing, which requires opening the cabinet.
Which dryers this applies to
This reading applies to Bosch dryers that report E12 as overheating due to restricted airflow. It does not cover Bosch washers or other brands. No model-specific E12 page exists yet; vented and condenser models differ in their air paths, so check the installation and care guides for your model.

