What this family is
This page covers the WM washers as one platform: the models carrying that prefix share a drum suspension, a drain path and a door-lock arrangement, and those three account for most of what goes wrong. Identify the symptom below, then follow the link to the article that handles it.
What goes wrong on these models
- Water left in the drum at the end of a cycle — A cycle that finishes with the drum still full and the load soaking. On this platform the pump filter is the first thing to open and it is almost never empty. Covered in full on "Blomberg WM washer not draining".
- No cycle begins when start is pressed — A click from the door area and then silence, which puts the fault at the latch rather than the control. Covered in full on "Blomberg WM washer not starting".
- A sound the machine did not make before — A rising metallic rumble that tracks drum speed, which is the one sound on this page with a deadline. Covered in full on "Blomberg WM washer making noise".
- Water on the floor — Water at the front during the wash, or a puddle at the back that is there when the machine is idle. Covered in full on "Blomberg WM washer leaking water".
- The programme halts partway — Repeated slow spin attempts that each abandon, which is balance correction giving up. Covered in full on "Blomberg WM washer stopping mid-cycle".
Fault classes, most reported first
- The drum does not empty — The most reported fault on this family, and the majority end at a filter that has never been cleaned.
- The programme never gets under way — Second by frequency here, and the fault class where an avoidable service call is most likely.
- Banging, rumbling or scraping — Regularly reported here, and the free checks resolve the majority.
- Water escaping onto the floor — Steady on these models, and the back-of-machine cases are the ones that deserve urgency.
- Cycles that stop before they finish — Fifth on this family, and usually a slow condition rather than an absent one.
Which models this profile covers
Reference| Family key | Appliance | How to identify it | Faults covered here |
|---|---|---|---|
| blomberg:washer:wm | Washer | The WM prefix on the rating-plate model number | Water left in the drum at the end of a cycle · The machine will not start a cycle · Banging, rumbling or scraping · Water on the floor · The cycle stops partway through |
Fault classes on this family — reported ordering, no measured shares
General guidance| Problem class | Where it is covered | Owner-fixable on these models? |
|---|---|---|
| Water left in the drum at the end of a cycle | family page | partly |
| The machine will not start a cycle | family page | sometimes |
| Banging, rumbling or scraping | family page | partly |
| Water on the floor | family page | partly |
| The cycle stops partway through | family page | sometimes |
Before any check on these models
Safety
Unplug the machine and close both taps before opening a filter or a connection. A washer holds a substantial volume of water and its supply hoses are under mains pressure whenever the taps are open.
What is owner work on this family
On these models the owner-side list ends where the cabinet opens. Filters, hoses, seals, taps and levelling are yours; pumps, pressure switches, bearings and control boards are not.
Other families of this brand and appliance
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
