The answer first
K models take this one slightly differently. Find the puddle before you find the cause. Water inside the cabinet under the crispers is a blocked defrost drain; water behind the unit is the supply line or its connections; water at the door is condensation from a seal that is not sealing. The departure from the generic page is in where the first check goes.
The observations that matter on a K unit
- Ice building up on the floor of the freezer — Melt water freezing where it stands because the drain below it is already blocked with ice. This is what an owner of a K refrigerator sees first.
- A damp patch on the wall or floor behind the appliance — That is the supply side, not the defrost side, and it is a fitting or a line.
- Water only after the appliance has been moved — A line that has been kinked, pulled or unseated during a clean is the most likely story.
- The puddle is on one side rather than centred — Useful: melt water leaving a cabinet that is out of level goes to the low corner.
- NEAR MISS: water is coming from the dishwasher alongside it — Worth ruling out before anything is dismantled; a shared cabinet run hides which appliance is wet.
The ranking on the K line
- A defrost drain blocked with ice or debris — Ranked first by a wide margin. Every automatic-defrost refrigerator makes melt water on a cycle, and the only path out is a narrow drain that clogs with food fragments and then freezes solid. On a K unit this is still the first thing to eliminate.
- A drain trough displaced or iced at the back of the compartment — The water never reaches the drain hole at all, so flushing the hole finds nothing wrong with it.
- A cracked water reservoir or dispenser line inside the door — Last, because it is the least common. It shows as water in the door shelves rather than at the back.
What to check first, second, third
- Find where the water actually is before touching anything — Inside under the crispers, behind the unit, or at the door sill — three locations, three different faults, and this single observation picks the branch. The K layout is the reason it comes first here.
- Look into the freezer for a sheet of ice on the floor of the compartment — Ice that keeps rebuilding after you chip it away means the drain below it is frozen.
- Put a spirit level on the top of the cabinet — A unit tilted forward drains the wrong way, and it takes a turn of the front feet to correct.
- Look at the drain trough at the back of the compartment, not just the hole — A trough knocked out of position sends water down the liner instead of into the drain.
What to do before you start
Safety
Isolate the appliance at the plug or the breaker first, then close the water shut-off. Mop the floor before you start rather than after; standing water around a mains appliance is the hazard, not the inconvenience. Never clear a frozen drain with a flame or a heat gun.
Models in the K family
Reference| Model number | Family key |
|---|---|
| K60340N | beko-amp-blomberg:refrigerator:k |
When to stop and call
The owner side ends at the rear evaporator panel and at any fitting that needs a tool to hold it still. Call then. Call immediately if the appliance trips a breaker, which means water has already found something it should not have.
Related symptoms for the K line
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
