The short answer
On the Avanti FLW models covered here a refusal to start is most often the lid or door circuit, the power supply or a setting rather than a failed control. This is a heavy, tightly sealed drum behind a door boot, with a drain pump and filter behind the lower panel, a counterweighted suspension and a control that will not proceed until the door is locked — and the control will not proceed until it is satisfied about the door.
What you observe on these models
- Completely dead — no lights, no sounds — A power report.
- Lights on, cycle selected, nothing happens — The control is alive and refusing.
- No lock sound after pressing start — The lock should be audible within a second or two.
- It worked an hour ago and now will not — A thermal cut-out that has not reset, or a supply that has dropped out.
- NEAR MISS — it starts and then stops mid-cycle — That is a stalled-cycle fault, not a start fault, and it belongs on the cycle page.
Causes, most likely first on FLW
- The lid or door latch — A machine that will not confirm its door is shut will not begin. On a front-loader you should hear the lock engage a moment after start. Ranked first on Avanti FLW because everything on a front-loader sits downstream of the door boot and the pump filter, so that is where the diagnosis starts rather than where it ends.
- Program selection, delay start or a child lock — A delay timer left set, or a child lock engaged by a stray press, accounts for a meaningful share of these calls and costs nothing to rule out.
- Power at the machine — Outlet, breaker and plug come first because they are free to check and because a machine with no display and no lock sound has no power, whatever the owner has assumed.
- A motor thermal cut-out — A motor that has overheated will refuse to restart until it has cooled, which produces a machine that worked an hour ago and will not now.
- The control board or the timer — Last, because it is both the least likely and the most expensive, and because every item above it mimics it exactly. Last on this list, and the item that every cause above it can imitate exactly.
Check in this order, and why that order
- Prove the outlet with something else — A lamp or a phone charger in the same outlet takes ten seconds and settles the most common cause outright.
- Close the lid or door firmly and listen — The lock or switch should be audible. If it is not, everything downstream of it is explained.
- Confirm the taps are open — Several machines will not begin without water available, so a tap closed during other work presents as a refusal to start.
- Leave it thirty minutes and try again — A motor thermal cut-out resets on cooling. A machine that starts after a rest has told you something specific about what was wrong.
Before you open anything
Safety
Unplug the washer or switch off its breaker before removing any panel, and close the tap before touching a fill hose. A capacitor can hold a charge after the power is off, and the door lock stays engaged for a period after a cycle ends — wait it out rather than forcing the door. Do not test an outlet by touch and do not bypass a lid or door switch to make the machine run: the switch exists to stop the drum turning while it is open, and defeating it removes the only protection in the machine.
Models this page covers — the FLW family
Reference| Model number | Family key |
|---|---|
| FLW22V0W | avanti:washer:flw |
When to call a technician
Call when the outlet is proven good, the lid or door lock is silent or clearly damaged, and no setting explains it. Call immediately if the machine trips protection when it is plugged in, if there is a burning smell, or if it hums and heats without moving. On Avanti FLW the outlet, the lock and the settings account for most of these reports, and a technician will begin with exactly those three. Check the plate before acting on any of this. FLW is a compact front-load washer, and the ranking above is written for that construction rather than for the brand as a whole.
Other problems covered for the FLW family
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
