What this usually is
An Artt dryer that does nothing when you press start is most often held by its door circuit or by a setting rather than broken. Push the door until it latches with a positive click, cancel any delay or lock, and confirm the panel lights. A completely dark panel points at the outlet, the plug or the breaker.
What you actually see
- Panel dark, no response at all — Supply: outlet, plug or breaker.
- Panel lit, nothing when start is pressed — Door circuit, a lock, or the start switch.
- A hum with no drum movement — Motor capacitor or a jammed drum.
- Starts and stops within seconds — The door circuit making and breaking, or protection.
- NEAR MISS: a delay-start countdown running — The machine is doing exactly what it was told.
The ranking that matters
- Door catch worn or misaligned — First, and it is the classic ageing fault: the latch sits a fraction short of the switch.
- A setting: delay start or child lock — Second, and free to rule out.
- No supply at the outlet — Third, and settled with a lamp.
- Start switch or membrane panel — Fourth, and it wears where one button is pressed daily.
- Motor capacitor or a jammed drum — Last, and it gives the hum-without-rotation signature.
A sequence that saves time
- Close the door firmly until it clicks — Instant, free, and it resolves a large share of these.
- Cancel delay start and child lock — Both are invisible unless you look for them.
- Check whether the panel lights at all — Dark means supply; lit means downstream.
- Turn the drum by hand with the machine isolated — Free movement rules out a jam.
Steps up to the stopping point
- Push the door shut until the catch clicks positively — A door that closes without latching reads as open to the machine and blocks everything.
About 5 min
- Cancel any delay-start countdown and child lock — Hold the button the panel indicates; the arrangement differs between machines.
About 10 min
- Plug a lamp into the same outlet — A dark lamp means the socket is the fault, not the dryer.
Tools: table lampAbout 5 min
- Isolate the machine and turn the drum by hand — It should rotate freely. Stop here rather than opening the cabinet.
About 10 min
Power off, panels later
Safety
Unplug the appliance or switch off its breaker before removing any panel — a capacitor can hold a charge after the power is off, and a dryer's motor capacitor is one of the components most likely to still hold one. A standard household branch circuit is 15 A or 20 A. The door switch must be left exactly as it is: it exists so that a heated drum cannot turn with the door open, and no starting fault justifies interfering with it.
When to stop and book someone
Call when the door latches positively, no lock is set, the outlet is proven live and the machine still will not start, because the door switch, start switch and control all need testing on an isolated machine. Call an electrician instead if the breaker trips on reset with the dryer unplugged. Mention any hum, click or smell when you book, because those change both the diagnosis and the parts brought.
Pages like this one
Where this page stops
This page is the class-level answer for an Artt dryer that will not start. It publishes no switch part numbers, no wiring colours and no control identifiers, because those differ between builds under this badge. Where a family- or model-specific page exists it carries those and is the better answer for a named model. Household wiring beyond the socket belongs to a licensed electrician.
Where to go next
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
