What you are looking at
An Arietta refrigerator that will not run after a power cut is often protecting itself rather than broken: the overload protector has tripped on a restart against unequal pressures and it needs time. Leave the unit powered and undisturbed rather than cycling it. If the interior light is dark as well, the fault is supply and the cut may have tripped a protective device in the house.
The observable signs
- Nothing at all after a power cut — Check the house first: the cut may have tripped a device that has not been reset.
- Light works, compressor silent, after a cut — Protection tripped. Give it time before doing anything else.
- Runs for seconds then stops, repeatedly — The overload cycling. Repeated attempts make it worse rather than better.
- Runs continuously but the cabinet is warm — Not a starting fault at all: that is the cooling page.
- NEAR MISS: a panel showing an odd display after a cut — A latched state. A proper power cycle usually clears it.
Likely causes on this brand
- Overload protector tripped after restart — First in this specific history, because a restart against unequal pressures is exactly what it protects against.
- A household protective device tripped by the cut — Second, and the reason to look at the consumer unit before the appliance.
- Start relay failure — Third. Common in general, and a cut often finds a relay that was already marginal.
- A latched control state — Fourth, and cleared by a proper power cycle rather than a quick flick.
- Compressor damage — Last, and rare, though repeated forced restarts make it likelier.
The order to work in, and why
- Check the consumer unit and any protective device — The cut may have left something off in the house.
- Look at the interior light — Present means supply is fine and the fault is inside.
- Leave the unit alone for a while — Actively unhelpful to keep trying. Pressures need time to equalise.
- Then power down properly and back up — Several minutes off, which clears a latched state.
Hands-on, without tools you do not own
- Reset any tripped device in the consumer unit — Once. If it trips again, stop and call an electrician.
Tools: torchAbout 10 min
- Leave the refrigerator plugged in and undisturbed — Do not keep switching it on and off; that is what causes the repeated protection trips.
About 45 min
- Power down at the breaker for several minutes, then restore — A genuine reset for a latched control state.
About 10 min
- Listen for the compressor starting and running — A start followed by a normal run means it has recovered. Stop here rather than opening any panel.
About 15 min
Power off, panels later
Safety
Unplug the appliance or switch off its breaker before removing any panel — a capacitor can hold a charge after the power is off. Do not repeatedly force a compressor to start against protection: each attempt heats the winding it is protecting. If the power cut was accompanied by a surge, a burning smell or a scorched socket, do not restore power to the appliance at all until an electrician has looked at the circuit.
The line for a service call
Call when the supply is proven, the unit has been left to settle and a proper reset has been given, and it still will not run. Call an electrician first if a household device trips again on reset, because that is a circuit fault rather than an appliance one. If the cabinet has been warm for hours, deal with the food before either call: a refrigerator holds food safely at 40 degrees Fahrenheit or below and the contents are on a clock.
Pages like this one
What this page does not cover
This page is the class-level answer for an Arietta refrigerator that will not start after a supply interruption. It carries no relay identifiers, no board part numbers and no wiring colours, because those differ between builds under this badge. Where a family- or model-specific page exists it holds those. Household wiring, protective devices and supply quality are an electrician's territory rather than an appliance technician's.
Other faults on this machine
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
