The short answer
On the Arctic Wind ATLG washer line, a water leak is worth working through in a set order: the detergent drawer, or the standpipe backing up first, then inlet hoses, their washers or the drain hose connection, and only after those does the work that needs a meter or a teardown enter the picture. That order is written for a single-model line and sequenced for how these models are put together, which is where it departs from the brand-generic article.
What you observe
- Water over the front edge during fill, or at the standpipe during drain — Two different moments, two different causes, both outside the machine itself.
- Water appears at the back and only while the machine is filling — Timing that tracks the fill puts it on the pressurised side.
- NEAR MISS — the drum is full of water and the floor is dry — That is a drainage fault, and the drainage page ranks those causes properly.
Causes, most likely first on the ATLG line
- The detergent drawer, or the standpipe backing up — The first thing to suspect: a drawer blocked with softener overflows forwards every fill, and a standpipe too narrow or partly blocked sends the machine own drain water back over the top — both put clean water on the floor at a very predictable moment in the cycle.
- Inlet hoses, their washers or the drain hose connection — Hose connections leak under pressure and then stop, so they explain a puddle that comes and goes with the cycle.
- The door seal or boot, or too much detergent — A dirty seal and an over-dosed drum both leak forwards, which is what separates them from a hose fault at the back.
- The pump filter cap or its housing — The filter cap is the quiet explanation for a leak that started shortly after someone cleaned the filter.
- The tub seal, the outer tub or a split internal hose — Last here, and the only cause on this list that is not owner work — a leak from the tub seal or a split internal hose only appears under the machine while it is running, and reaching it means the machine on its side or apart.
Check in this order, and why
- Pull the drawer right out and look into its housing, then watch the standpipe during a drain — Soft blockages in both are visible without tools. Done first because it separates the likeliest causes before any tool is needed.
- Pull the machine out, dry every fitting and watch them through a fill — Second: it confirms or dismisses what the first check suggested.
- Pull the seal open all the way round and look at its lower edge — Third, once the two checks above are clean.
Before you open anything
Safety
Unplug the appliance or switch off its breaker before removing any panel or kick plate, and shut both taps before touching an inlet hose — a capacitor can hold a charge after the power is off, and a machine standing in water beside a socket is a genuine hazard. Dry the floor before you start rather than after. Never run a machine with a panel removed to see where the water comes from.
Models in the ATLG family
Reference| Model number | Family key |
|---|---|
| ATLG45 | arctic-wind:washer:atlg |
When to call a technician
Call when the hoses, the seal, the drawer, the standpipe and the filter cap are all clean and dry and water still appears, because what is left is inside the machine. Shut the taps between washes while you wait.
Nearest pages of this class
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
