The short answer
The Arctic Wind AGDG dryer tumbling a cold load is the commonest dryer complaint there is, and most of the time nothing has failed permanently: a thermal cut-out has done its job because the machine could not get rid of its own heat.
What you see on the AGDG line
- Cycles have been getting longer for months — A gradual decline, which is the airflow signature rather than a component failure.
- The cabinet and the door get hot while the load stays damp — Heat is being made and is not leaving with the air, which points squarely at the duct.
- The machine was hot yesterday and is stone cold today — A sudden and total loss, which fits a thermal device or a lost supply leg.
- NEAR MISS - the machine stops part way through every cycle — A cycle that ends early is a different fault chain; see the cycle-fault page.
Ranked for the AGDG line
- Lint screen and exhaust duct restricted — Most likely here: A dryer works by moving heated air through the load and out, and a restricted duct means the heat stays in the cabinet until a thermal device cuts it off. The prefix on these models is the gas designation in this catalogue, with a companion line differing by a single letter; the ranking below assumes the gas heat train, and the other line ranks its own heat source first.
- One leg of the electrical supply lost, on an electric machine — Second: It is the check that explains a machine that tumbles perfectly and has never been hot since the day it stopped.
- Heating element or gas valve coils failed — Third: Valve coils on a gas machine fail in a way that lets the igniter glow without the burner ever lighting, which is a specific and recognisable sequence.
Check in this order, and why
- First - Clean the lint screen, then disconnect and inspect the whole duct run to the outside — Weak or cool air at the outside vent while the machine runs is conclusive. That is the order the roster on this page dictates, not a generic sequence.
- Second - Switch the machine's breaker fully off and back on, and check for a half-tripped double breaker — A drum that turns with no heat, on an electric machine, makes this the first electrical check.
- Third - Note whether the machine has been completely cold from the first failed cycle — Cold from the outset, with airflow and supply proven, points here and ends the checks.
Before you open anything
Safety
If you smell gas: do not switch anything on or off, leave the building, and call the gas utility or your local emergency number from outside. Do not look for the leak yourself. Otherwise, unplug the appliance or switch off its breaker before any panel comes away - a capacitor can hold a charge after the power is off - and close the appliance gas valve on a gas machine before anything is disturbed.
Models in the AGDG family
Reference| Model number | Family key |
|---|---|
| AGDG70U | arctic-wind:dryer:agdg |
When to call a technician
The line is the cabinet: the screen, the duct and the vent flap are yours, and anything behind a panel is not. Call the same day if the cabinet gets hot while the load stays damp, since that means heat is being made and not removed, which is the condition that starts dryer fires.
Nearest pages of this class
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
