Amana V Washer: Water Leak

Frequently Asked Questions

Can I keep using the machine?

Not if the leak is on the supply side or reaching a socket or the flooring. A small drain-stage leak can wait a few days if the floor is protected and dried after every cycle.

Why did it start leaking after the filter was cleaned?

Because the cap was not reseated squarely, or its seal was displaced. Remove it and refit it carefully before assuming anything has failed.

Should I replace the inlet hoses as a precaution?

They are inexpensive, they are under mains pressure whenever the taps are open, and their washers perish with age. Replacing them periodically is reasonable regardless of this fault.

Is this the same across the family?

The model matrix on this page lists the models covered. Where the filter and the pump sit varies across that span, and a seal ordered on the family badge alone is often the wrong one.

Why does it only leak on a hot wash?

Hoses and seals move as they warm, so a marginal joint opens at temperature and closes when cold. It is a real leak and it will get worse rather than better.

Can I just close the taps between washes?

It is a sensible habit and it limits what a failed inlet washer can do. It is a precaution rather than a repair, and it does nothing for a drain-side leak.

Can I stop the leak temporarily?

Close the taps between washes and dry the floor after every cycle. That contains a supply-side leak and buys time; it does nothing about a drain-side or tub leak.

Is a wet floor after every wash normal?

No. Some condensation on a cold cabinet in a warm room is normal; standing water is not, and it is worth locating before it reaches the flooring.

Could the detergent be causing it?

Over-dosing produces foam that escapes past seals that handle water perfectly well. Running one cycle with the correct dose is a five-minute test worth doing first.