The short answer
This fault reads the same on every make, but it does not rank the same. On the FC models it is usually a cabinet tilted so meltwater runs the wrong way. This line is a close pair of models rather than a spread, so the build is effectively uniform and the seal-and-fit causes come forward.
What you observe
- Water standing under the crisper drawers — Lift the drawers out to see it — the well is usually the last place people look and the first place to check.
- A trail of ice down the back of the ice bin — Spill from the fill that freezes on the way down.
- NEAR MISS — a slow drip from the water dispenser tray — A dispenser that drips after each use is a dispenser question, not a leak in the cabinet.
Causes, most likely first on the FC line
- A cabinet tilted so meltwater runs the wrong way — Ranked first here — it turns a drain that would otherwise cope into one that does not, and it is free to correct.
- A filter head or filter seal weeping — Second here — it is the one fitting inside the cabinet that gets disturbed regularly, which is when seals fail.
- A dispenser line dripping after use — Third here — it makes a small, repeatable puddle in one place and is ruled out by not using the dispenser for a day.
- Body: Two closely related models means what holds for one holds for the other, which is why the order below is stated without a hedge. Concretely, a cabinet tilted so meltwater runs the wrong way outranks a filter head or filter seal weeping here, and that is the difference worth reading for.
Check in this order, and why
- Check the cabinet sits slightly back on its feet, not forward — Doors that swing open on their own are the giveaway that it is leaning the wrong way.
- Dry the filter housing completely and look again an hour later — A filter fitted a shade off-seat, or an O-ring left behind by the old cartridge, will show as a bead.
- Stop using the dispenser for a day and watch the tray — Water that stops appearing places the fault at the dispenser and nowhere else.
- Body: Two closely related models share a layout, so a check that works on one works on the other and the order below does not change between them. Work them in order: each one clears the cause it sits beside, and the next is only worth doing once the one before it is clean.
Before you open anything
Safety
Unplug the appliance or switch off its breaker before removing any panel — a capacitor can hold a charge after the power is off. Water and an electrical appliance are a bad pair: dry the floor before you pull the cabinet out, and never work on a wet floor with the unit plugged in. Shut the water supply off at its valve before touching any fitting, and do not clear a drain with a metal probe.
Models in the FC family — Every model this page covers, exactly as the model line is recorded. Nothing outside this table is a model number, and nothing on this page claims to cover a model that is not in it.
Reference| Model number | Family key |
|---|---|
| FC2-671 | amana:refrigerator:fc |
| FC2-671.IM | amana:refrigerator:fc |
When to call a technician
Call when the water is coming from a fitting you cannot reach dry, when the drain will not clear with warm water, or when the interior floods again within a day of being cleared. Call at once if water is reaching wiring or a socket — that stops being a leak and becomes an electrical fault. Of the causes listed above, most are owner checks and the last is not — that is the line.
Nearest pages of this class
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
