Want a regional phone & address? Pick your area.
Electrolux·Washer (Kenmore)low severity
Electrolux Error Code lid
Lid not closed
Common Causes
- 1Lid not fully closed
- 2Lid switch failure
- 3Obstruction
Step-by-Step Troubleshooting
- 1
Press lid down firmly until it clicks — check for clothes caught in the seal
- 2
Clean lid strike area and magnetic switch zone of lint/debris
- 3
Test lid switch with multimeter — should show continuity when closed
- 4
Check wiring harness from lid switch to control board for breaks
Pro Diagnostic Tip
If the lid locks (you hear the click) but the error persists, the switch is sending an intermittent signal — replace the entire lid lock assembly rather than just the switch
You Might Also Notice
- •Washer will not start
- •Lid locks then immediately unlocks
- •Cycle pauses mid-wash
Parts, Cost & Difficulty
Repair Difficulty
Moderate — Some Experience NeededEstimated Repair Cost
$40–$150
Parts + labor. Free diagnosis with repair.
Parts That May Need Replacement
W10838613 — Lid switch assemblyW11307244 — Lid lock actuator
Do You Have the Right Tools?
Bearing puller set ($120), drum spider wrench ($85), multimeter ($85), and diagnostic software. Our technician arrives with $15K+ in professional tools — your diagnostic is free.
Licensed & Insured · 90-Day Warranty · Same-Day Service
What This Repair Involves
Here's what a professional technician does to resolve this issue:
Diagnose the root cause, test affected components with calibrated meters, replace faulty parts with OEM replacements, and verify proper operation through a full test cycle.
This repair requires bearing pullers, drum spider wrenches, and diagnostic software for control board calibration. Most homeowners find it safer and more cost-effective to have a licensed technician handle it.
Safety First — Know the Risks
High-voltage components and pressurized water lines create flood and shock risk. A single loose fitting can cause thousands in water damage. Our techs are licensed and insured — let them handle the risk.
Licensed & Insured · 90-Day Warranty · Same-Day Service
Ready to Get This Fixed?
Don't let error code lid disrupt your day. A professional diagnosis takes about 30 minutes — and it's free when you proceed with the repair.
Licensed & Insured · 90-Day Warranty · Same-Day Appointments Available
4.85 (232 verified reviews)
Same-Day Appliance Repair
Fixed or It's Free
$89 → $0 Service Call & Diagnosis — offer ends May 31
Frequently Asked Questions
What does Electrolux error code lid mean?
Electrolux error code lid indicates: Lid not closed. This is a low-severity issue affecting your washer (kenmore).
How do I fix Electrolux error code lid?
Press lid down firmly until it clicks — check for clothes caught in the seal Then, Clean lid strike area and magnetic switch zone of lint/debris Then, Test lid switch with multimeter — should show continuity when closed There are 1 more steps — see the full troubleshooting guide above. If these steps don't resolve the error, contact a professional.
How do I know if my washer (kenmore) has error lid?
Besides the error code on the display, common signs include: Washer will not start; Lid locks then immediately unlocks; Cycle pauses mid-wash. If you notice any of these symptoms, check your washer (kenmore)'s display panel for error code lid.
How much does it cost to fix Electrolux lid?
Repair costs for Electrolux lid typically range from $40 to $150 depending on the specific cause and parts needed. EasyBear offers free diagnosis when you proceed with the repair. Call (415) 795-7300 for a same-day appointment.