The short answer
FC E8 is a registration message rather than an appliance fault: the table says that if the appliance identifier was entered incorrectly a registration error appears, and asks you to enter the number again. The oven itself is unaffected. What has failed is the pairing between the appliance and the account, and it is corrected from the app.
Code table
Reference| code | meaning | owner-checkable |
|---|---|---|
| FC E8 | If the SAID number was entered incorrectly, the "Registration Error" will appear. Try entering the number again. If you need help locating the SAID number, please see "SAID Location" in the "Other Info" section of this troubleshooting | yes |
| FC E7 | The appliance did not connect to your router. | see page |
| FC E9 | There may be a problem with the Wi-Fi Power Module, or the associated wiring. | see page |
What you observe
- Registration fails at the identifier step — The number is rejected and the process stops there.
- The appliance never appears in the account — Pairing did not complete, so nothing is listed.
- Cooking is entirely unaffected — Nothing about registration touches the heating system.
- NEAR MISS — the appliance cannot reach the network at all — That is a connectivity code with its own page and a different fix.
Likeliest causes first
- The identifier was mistyped — First, and it is what the table names: the number mixes letters and digits and the usual confusions apply.
- The identifier was read from the wrong label — Second: the appliance carries several numbers, and only one of them is the registration identifier.
- The account or app session is stale — Last: a signed-out or timed-out session fails the step for reasons that have nothing to do with the number.
Check in this order
- Re-enter the identifier slowly, character by character — What the table asks you to do, and it resolves most of these.
- Confirm you are reading the right label — The manual shows where the identifier sits; it is not the model or serial number.
- Sign out of the app and back in, then retry — Clears a stale session, which fails the step identically.
Owner-safe steps
- Locate the identifier where the manual says it is — The troubleshooting section names its location; other labels on the appliance are not it.
About 10 min
- Enter it again, checking letters against digits — The characters that look alike are where these errors come from.
About 10 min
- STOP HERE — there is nothing to open and nothing to replace — This is an app-side message, not an appliance fault.
Safety first
Safety
Unplug the appliance or switch off its breaker before removing any panel — a capacitor can hold a charge after the power is off. An oven carries a heavy element circuit behind the rear panel, and the cavity stays dangerous long after the heat is off. Leave the door lock and its switch wired exactly as they are.
When to call
Call the app or brand support line rather than a repair technician: nothing here is a hardware problem, and an engineer visit cannot help with an account pairing. Keep the identifier and the model plate to hand when you do. The appliance meanwhile cooks normally, and you can leave it unregistered indefinitely with no consequence beyond losing the remote features.
Neighbouring codes — FC E7 and FC E9 appear beside FC E8 in the table and are recorded against different hardware — different questions with different answers. A shared prefix on this brand is not a shared fault.
What this page does not cover
Generalized information: this reads FC E8 as the shared Maytag oven table records it, so it covers the model lines using that table and no others. Where a page exists for your family or model line, that one is the more specific answer — start there if your model is named. Not here: wiring colours, connector positions and part numbers, which differ by family.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
