The short answer
F0E6 on this cooktop means the published entry answers this code with an instruction rather than a description: disconnect the cooktop from the power supply — that is what the manufacturer published for it, and no more. Follow the published instruction and leave it disconnected rather than working round it: the entry gives no condition under which it may be used. One of the checks below is an owner check, and the rest of the work is behind a panel.
Error codes
Reference| Code | Meaning |
|---|---|
| F0E6 | Disconnect the cooktop from the power supply. |
What the machine does alongside the code
- Zones may stop responding together rather than one at a time — A condition affecting the power side shows across the appliance rather than at one zone.
- The code appears and no published sequence clears it — Where the answer is isolation, there is no owner remedy to work through.
What triggers F0E6, most likely first
- A condition the manufacturer answers by removing the supply — It goes first because it is the whole of what the entry says: an instruction to disconnect rather than to reset marks a condition that is not meant to be cleared and continued, whatever the underlying component turns out to be.
- A supply or control condition recorded at the moment of the fault — What the cooktop was doing when the code appeared is the only diagnostic evidence available, since the entry names no component.
- A genuine fault in the control or its wiring — Last, and only where the code returns immediately: at that point the power cycle has done all it can and the fault is live.
Check in this order, and why
- Note whether other appliances on the circuit are affected — That single observation decides whether the visit should be electrical or appliance work.
- Time how long the appliance stays clear — Immediately, hours or days: that single number decides everything that follows.
- Note what was happening when the code appeared — Stage of the cycle, time of day and what else was running are all useful and all free.
The reset, then the owner-safe checks
- Use the appliance normally once and note the result — Normal operation after a reset is the evidence you need that the code was stored rather than live.
About 45 min
- Switch the cooktop off at the circuit breaker and leave it isolated, then record what was happening when the code appeared — Zones in use, settings, how long it had been running and anything else on the circuit.
About 15 min
- Keep a short note of every appearance — Date, stage and what else was running. Two or three lines is enough to turn guesswork into a diagnosis.
About 5 min
- STOP HERE — do not repeat the reset indefinitely — A code that returns each time is live. Resetting round a live fault hides it rather than fixing it.
Before anything is opened
Safety
Isolate the cooktop at its circuit breaker before any panel comes off — a capacitor can hold a charge after the power is off, and this is a fixed high-current appliance rather than one you unplug. Put nothing cold or wet on hot glass. On a gas model, if you smell gas, leave the building and call the gas utility from outside.
When this is a service call rather than a reset
Call with your notes rather than with the code alone.
Neighbouring codes on KitchenAid cooktops
What this page does not cover
This reading applies to the KitchenAid cooktop line as a whole, not to one family or model. It does not cover what differs between model lines — wiring colours, connector positions, part numbers and service-mode sequences — which are in your own model manual and which a technician matches to the rating plate rather than to this code. Where a family- or model-specific page for this code exists, it is linked from the code index below and it is the more specific answer.
Links: - [KitchenAid cooktop error codes](/blog/kitchenaid-cooktop-error-codes)
Where to go next
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
