The reading in two sentences
F00 on this cooktop means an object, liquid or soil is putting pressure on the control panel — that is what the manufacturer published for it, and no more. The panel is locked out while something is on it, so clear and dry the surface before cooking. One of the checks below is an owner check, and the rest of the work is behind a panel.
Error codes
Reference| Code | Meaning |
|---|---|
| F00 | An object, liquids, or soils are putting pressure on the control panel. |
What else is happening when this shows
- The fault clears when a cloth or lid is taken off the panel — Which identifies the cause without any further work.
- Tones sound with nothing being touched — The panel is reacting to something on its surface rather than to a finger.
- NEAR MISS — the panel is dark and does nothing at all — That is a supply or a link fault rather than a surface one, and it is checked differently.
What triggers F00, most likely first
- Something resting on the panel — It goes first because the meaning names it first and because it is instant and free to rule out: a cloth, a lid or a utensil on the control area reads as a finger held down.
- Steam or condensation on or behind the glass — Moisture arriving from a hot cycle or a kettle underneath produces the same false press and clears as the panel dries, which is why the fault comes and goes.
- A failed interface board behind the panel — Last: the expensive candidate, and the only honest way to reach it is to have the surface clean, dry and unloaded first.
The order to work through
- Dry the surface and check it in reflected light — A film shows at an angle when it is invisible head-on.
- Take everything off the panel, including anything overhanging the edge — Then try one key before cleaning anything.
- Clear everything off the control surface — Not most things — everything, including a cloth draped over the edge.
The reset and the checks that follow it
- Cut power at the breaker for a minute and restore it — A panel that has locked out needs the control to re-read a clean surface from cold.
About 5 min
- Clear the panel, clean it with detergent on a cloth, dry it fully and power-cycle at the breaker — A locked-out control often keeps the code until it re-reads a clean surface from cold.
Tools: cloth, mild detergentAbout 15 min
- Let a steamed-up panel dry out before judging it — If the fault follows steam, leave the appliance off and dry until the glass is clear, then retest.
About 60 min
- STOP HERE — the membrane and its connector are behind the glass — Getting behind a control panel means live terminals, so that is service work.
Before a panel comes off
Safety
Isolate the cooktop at its circuit breaker before any panel comes off — a capacitor can hold a charge after the power is off, and this is a fixed high-current appliance rather than one you unplug. Put nothing cold or wet on hot glass. On a gas model, if you smell gas, leave the building and call the gas utility from outside.
Where an owner check ends
Call straight away if the overlay is cracked, lifting or has taken water underneath, or if the same key keeps failing on a clean dry panel.
Other codes on a KitchenAid cooktop
What is deliberately not here
Treat this as the general KitchenAid cooktop reading. It stops short of anything model-specific — part numbers, harness colours, connector layouts and service-mode entry — because those differ by family and a technician takes them from the rating plate rather than from a code. A family- or model-specific page, where one exists, is linked from the code index below and is the closer answer.
Links: - [KitchenAid cooktop error codes](/blog/kitchenaid-cooktop-error-codes)
Next steps
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
