In brief
Jenn-Air documents F2 E6 as a possible problem with the user interface or keypad, the control, or their wiring. With this code keys may not respond, may respond twice or may seem to press themselves. Because a faulty user interface or keypad can start or change a function on its own, keep the oven off at the breaker when it is not in use until the fault is fixed.
Error codes
Reference| Code | Meaning |
|---|---|
| F2 E6 | There may be a problem with the User Interface or Keypad, the Control, or the associated wiring. |
What you will notice
- The code followed a clean of the panel — Spray, water or a damp cloth was used on the control panel shortly before the code.
- Settings change on their own — Temperature or time steps up or down, or a function starts or cancels, without a press.
- NEAR MISS: a lock symbol and no response — A control lock disables the keys on purpose; the use-and-care guide explains how to release it.
What triggers the code, in likelihood order
- Moisture or cleaner behind the panel — Ranked first when F2 E6 appeared soon after the panel was cleaned: liquid that runs behind a keypad bridges key circuits, and the code can clear once it dries.
- A worn or damaged keypad — Membrane keypads crack and wear at the most-used keys, and a damaged key either goes dead or registers on its own.
- The ribbon cable or its connector — The keypad joins the control through a flat ribbon tail; a crack in the tail or a connector not fully seated gives intermittent keys and this code.
What to check first, and why
- Let the panel dry — If cleaner or water reached the panel, leave the oven off at the breaker until it has dried fully.
- Rule out the control lock — Make sure the control lock is not set; a locked panel ignores keys by design.
- Test each key once — Press every key in turn and watch for exactly one response; note any that are dead, slow or double.
What an owner can safely do
- Dry the panel — Wipe the panel with a dry cloth and leave the oven off at the breaker for at least an hour while moisture behind it evaporates.
Tools: dry soft clothAbout 60 min
- Reset the control — Switch the oven off at the breaker for a few minutes, then back on, and see whether the code returns.
About 5 min
- Stop here if the next check needs a meter — Testing a part or its wiring means live terminals or disassembly, which is technician work.
Safety before any check
Safety
Unplug the appliance or switch off its breaker before removing any panel. A capacitor can hold a charge after the power is off. The control console holds live terminals behind the keypad; keep liquids away from it and leave the console closed.
When to call a technician
Call for service if F2 E6 returns after a reset with the panel dry, if any key presses itself, or if the oven starts, stops or changes temperature without a command. A user interface or keypad that acts on its own is a safety issue, so keep the oven off at the breaker until it is repaired.
Nearby codes on the same oven line
Scope of this code reading
What this covers: F2 E6 as Jenn-Air documents it for Jenn-Air ovens and ranges whose code list carries F2 E6 as a user interface or keypad fault. What it does not cover: the control lock indicator, cooktop-only codes, and models that read F2 E6 differently, or the wiring colors, part numbers and test values of any one model. A model-specific page for your unit, where one exists, outranks this general reading.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
