What the code means
F1E1 means the oven was asked to do something, such as bake, broil or clean, and could not execute it; the documentation points at the relay control board or the wiring around it. Treat that function as out of service until the code clears and stays clear.
Error codes
Reference| Code | Meaning |
|---|---|
| F1E1 | The oven could not execute the function. There may a problem with the Relay Control Board, or the associated wiring. |
What you will notice
- Only one function fails — Bake may run normally while broil or another mode raises the code each time.
- Some functions work and others do not — A plain bake may run while broil or convection raises the code, because each function uses different relays.
- NEAR MISS: nothing on the display at all — No display is a supply fault; check the breaker and the cord or terminal block first.
Causes, most likely first
- A worn relay on the relay control board — Ranked first when F1E1 follows one function and not the others: each function closes its own relays on the relay control board, so a single failing function points at a single relay or the load behind it.
- The part the function drives — If the board switches correctly but the element or fan does not respond, the function still fails; testing tells the two apart.
- An open wire or burnt terminal between the board and the load — High-current wiring to the elements runs hot; a terminal that has burnt or a wire that has opened stops the function as surely as a failed relay.
What to check first, and why
- Find which functions raise the code — Try bake, broil and any convection or clean mode in turn, briefly, and note which ones fail. One failing function and several are different faults.
- Listen for the relay click — A click when the function starts means the board is trying; no click points further upstream.
- Reset at the breaker — One clean power cycle shows whether the code is latched from a disturbance or live.
Clearing the code and safe checks
- Test each function briefly — Run bake, then broil, then any convection mode for a couple of minutes each, attended, and note which one brings the code back.
Tools: notebook or phoneAbout 15 min
- Watch the elements — Where an element is visible, it should start to glow soon after its function starts; one that stays dark is worth reporting. Look, do not touch.
Tools: flashlightAbout 5 min
- Stop here if the next check needs a meter — Testing a part or its wiring means live terminals or disassembly, which is technician work.
Safety first
Safety
Unplug the appliance or switch off its breaker before removing any panel. A capacitor can hold a charge after the power is off. The wiring between the relay board and the elements carries heavy current and runs hot; a burnt terminal can arc when disturbed.
When it is a service call
If F1E1 returns on the same function after a power cycle, the next step is a technician: the relay, the wiring and the element or fan it drives all need testing under power to find which one stops the function.
Neighboring Jenn-Air oven codes
What this reading does not cover
What this covers: F1E1 as Jenn-Air documents it for Jenn-Air ovens whose code list carries F1E1 as a function the oven could not execute, with the relay control board named. What it does not cover: Jenn-Air cooktops, hoods, or models whose documentation reads F1E1 differently, or the wiring colors, part numbers and test values of any one model. A model-specific page for your unit, where one exists, outranks this general reading. A second Jenn-Air listing gives the same code other wording; confirm which one fits your model.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
