Short answer first
F02 means the control cannot get a believable temperature reading from the oven temperature sensor: the sensor, the control or the wiring between them is suspect. Treat the oven as out of service, because an oven regulating on a bad reading can run far too hot or too cool.
Error codes
Reference| Code | Meaning |
|---|---|
| F02 | There may be a problem with the Oven Temperature Sensor, the Control, or the associated wiring. |
What you observe
- The code shows once the oven is hot — The oven reaches temperature normally and raises the code partway through cooking.
- Preheat overshoots or never finishes — A sensor reading wrong makes the control heat too long or stop too soon.
- NEAR MISS: temperature slightly off with no code — A small, steady offset is a calibration matter, and many controls let you adjust it from the settings.
Causes, most likely first
- Sensor wiring damaged by heat or pinching — Ranked first when F02 waits until the oven is hot: the sensor's harness runs behind the oven, where heat hardens insulation and loosens a connector that only opens as it expands.
- The sensor connector behind the oven — The sensor plugs into the harness at the back wall; a connector pulled half off, corroded or heat-darkened breaks the reading.
- A failed or drifting oven temperature sensor — A sensor that reads wrong, or not at all, is the most direct way to produce this code, and it is a part that wears.
What to check first, and why
- Reset and note the timing — Power-cycle at the breaker, preheat once, and note whether the code returns at once or only when hot.
- Check what came before — A code that started after a self-clean or after the range was moved points at heat or pinch damage to the sensor wiring.
- Compare with an oven thermometer — If the oven still heats, a separate thermometer shows whether it is regulating far off its setting.
Reset and owner-safe checks
- Record when it happens — Note whether the code appears at preheat, mid-bake or after a clean; it decides the order of a technician's tests.
Tools: notebook or phoneAbout 2 min
- Reset the control — Switch the oven off at the breaker for a few minutes, then back on.
About 5 min
- Stop before any panel comes off — Everything past this point needs live measurements or a panel removed; that is the line between an owner check and a service call.
Before you open anything
Safety
Unplug the appliance or switch off its breaker before removing any panel. A capacitor can hold a charge after the power is off. An oven that keeps heating with a sensor code can overheat; if that happens, switch it off at the breaker rather than at the panel.
When it is a service call
Call for service if F02 returns after a reset, or at once if the oven keeps heating with the code showing or runs far hotter than its setting. Measuring the sensor and its harness against the model's specification is the test that decides the repair, and it needs a meter and the oven's rear connections.
Neighboring Jenn-Air oven codes
What this reading does not cover
Generalized information: F02 is read here for the Jenn-Air oven line as a whole, which fits Jenn-Air ovens whose code list carries F02 as a temperature-sensor fault. It is not a reading for meat-probe codes, microwave and cooktop sensor codes, and models that read F02 differently. Model lines can reuse a code with another meaning, so a model-specific page, where one exists, comes first.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
