The short answer
On a Frigidaire gas range, clicking that stops the instant a burner lights is the igniter doing its job. Clicking that carries on means no flame has been sensed, and a cap sitting slightly off its base is the usual reason. Roaring, whistling and a flame that lifts off the ports are combustion faults, and those end owner diagnosis rather than starting it.
Causes, ranked for this Frigidaire gas stove
- Burner cap not seated on its base — Why: The caps locate precisely, and one replaced fractionally off after cleaning spoils the flame pattern and stops the flame being sensed, so the igniter keeps calling.
- Moisture in the igniter after a spill or cleaning — Why: A wet igniter keeps sparking because no flame is confirmed, and it stops on its own once the area has dried properly.
- Burner ports silted with spillage — Why: Blocked ports give an uneven, noisy flame and are cleared with a pin and a soft brush rather than any replacement part.
- Air shutter or supply pressure wrong — Why: A roaring or lifting flame means the air-to-gas mixture is wrong, which is set with instruments and belongs to a technician.
- Orifices wrong for the fuel supplied — Why: A range converted between natural gas and propane, or never converted when it should have been, burns loudly and badly — uncommon but important to exclude.
What to check, in order
- use your nose first and follow the evacuation instruction below if you smell gas. — Because: nothing on this page matters beside a possible leak.
- note whether the clicking stops once the burner lights. — Because: that single observation separates a working igniter from a real fault.
- lift every burner cap and reseat it precisely. — Because: it is the top cause, it takes seconds, and it fixes both the noise and the flame.
- look at each flame for colour, shape and lift. — Because: a roaring, lifting or yellow flame is a combustion fault and ends owner work.
Checks you can safely do yourself
- If you smell gas at any point, stop and follow the evacuation instruction below instead of continuing. — Tools: none — Time: immediately
- With the range cool and off, lift each burner cap, clean the cap and base of spillage, and reseat it precisely in its location. — Tools: a cloth — Time: several minutes
- Clear the burner ports with a pin and a soft brush without enlarging any port. — Tools: a pin and a soft brush — Time: several minutes
- Dry the igniter area thoroughly after any spill and allow time before retrying the burner. — Tools: a dry cloth — Time: several minutes
- Light each burner and watch the flame, noting any that roars, lifts or burns yellow. Stop here: shutters, orifices and pressure are technician work. — Tools: none — Time: several minutes
Before you open anything
Safety
gas-smell-evacuate unplug-before-service
Never enlarge a burner port, adjust an air shutter or change an orifice yourself, and never test for a leak with a flame. If a burner will not light while gas continues to flow, turn it off and let the area clear before trying again. Treat any smell of gas as the priority over any diagnosis.
Where the owner fix ends
Reseating caps, clearing ports and drying an igniter are owner work. Call a technician for a roaring or lifting flame, a whistle that changes with the setting, a persistently yellow flame, or any doubt about the fuel the range is set for, since all of those are measured rather than judged by ear.
Nearest pages of the same kind
Generalized information — what this page does not cover
family model
This page is generalized information about Frigidaire gas ranges and cooktops and does not separate sealed-burner families, models with different burner counts, or units converted between natural gas and propane, all of which change the sounds described. No family-level or model-level page exists in this reference yet; when one is published it will be linked here.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
