The short answer
On the Costway FP dryer family a dryer that tumbles without heating is nearly always an airflow story: a restricted exhaust or a blocked lint path overheats the machine, and a thermal cut-out opens to protect it. The brand-generic article opens with the heating element because it covers every chassis; on these models the element is usually innocent and the vent is not.
What you see on the FP family
- The drum turns for a full cycle and the load is still damp — The machine is running perfectly and producing no heat, which is the defining case for this page.
- The load is damp and the machine feels hot to the touch — Heat is being made and is not leaving, which is the airflow case rather than the element case.
- Cycles that used to finish now take much longer — A gradually restricting exhaust shows up as time before it shows up as no heat at all.
- A hot or scorched smell around the machine — Lint accumulated where heat has to escape. Stop the machine and clear it before running anything else.
Causes, most likely first on the FP family
- Restricted exhaust, lint filter or duct — Ranked first on the FP family — it is the most common cause of no heat on the Costway FP dryer family and the one that causes the other causes. Lint collects in the filter housing, in the duct behind the machine and at the outlet, and a dryer that cannot exhaust cannot dry.
- Thermal fuse or thermal cut-out opened — Second — and inseparable from the first: the fuse opens because the airflow failed, so clearing the vent is part of the repair. A one-shot thermal fuse opens permanently after an overheat and kills the heat circuit, leaving a machine that tumbles cold.
- Heating element or the heat circuit — Third — less common than airflow and always worth checking after the vent rather than before it. An element that has burned through makes no heat while everything else runs normally.
- Thermostat, control board or a moisture sensor misreading — Fourth — and the one to consider once the vent, the fuse and the element are all accounted for. A cycling thermostat that has failed open never calls for heat.
- Body: With only 2 codes in the FP family the ranking below is taken over a short roster rather than over everything the brand sells, which is why the top of this list is not where the brand-generic article puts it.
Check in this order, and why
- 1. Pull the lint filter and look at the housing behind it — Clean the screen and check the cavity underneath, because a filter that looks clear can sit above a packed housing.
- 2. Feel the cabinet and the load after a short run — Hot cabinet with a damp load is airflow; cool cabinet with a damp load points at the heat circuit.
- 3. Disconnect the exhaust and run the machine briefly — If it heats with the duct off, the duct is the fault.
- Body: The 2 codes in the FP family are close enough in layout that the order below holds across all of them; check the plate on your own unit against the table before you order anything.
Before you open anything
Safety
Unplug the appliance or switch off its breaker before removing any panel — a capacitor can hold a charge after the power is off. A standard US household branch circuit is 15 A or 20 A at 120 V, and a large appliance circuit is typically 30 A or higher at 240 V, so treat the supply as lethal and isolate before opening anything.
Models in the FP family
Reference| Model number | Family key |
|---|---|
| FP11243US-WH | costway:dryer:fp |
| FP11244US-WH | costway:dryer:fp |
When to call a technician
Call once the filter and the duct are clear and the machine still tumbles cold, because the next steps are the thermal fuse, the element and the supply, and all three sit behind a panel on these models.
Other FP dryer pages
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
