Start here
The panel is the messenger; the message is usually about the filter or the tap. Nothing here needs the panel opened. On this kind of cabinet the line is a volume sub-brand of a large manufacturer, which means the platform is well understood and the parts are ordinarily obtainable.
Symptoms worth separating
- Buttons respond erratically or select themselves — Often moisture behind the fascia instead of a board fault.
- NEAR MISS — the machine is completely dead — No lights at all is a supply question and belongs on the start-up page.
- The machine forgets its settings — Points at supply quality or a control losing its stored state.
- The panel lights but no button responds — Usually a child lock instead of a fault.
What is usually behind it
- Child lock or delayed start engaged — Ranked first: They are cleared from the front panel in moments and cost nothing to rule out. It sits at the top here since the line is a volume sub-brand of a large manufacturer, which means the platform is well understood and the parts are ordinarily obtainable.
- Door catch reporting intermittently — Second: It is the most frequently replaced electrical part on a dishwasher, which is why it ranks high.
- A real condition: drain, fill or door — Third: Clearing the filter and opening the tap resolves a large share of what homeowners describe as control faults.
Order of investigation
- Check the filter, the tap and the door — Most indications name one of these three, and all three are homeowner-accessible.
- Switch off at the spur for several minutes — A full power-down is a reset; switching the panel off is not.
- Check the drain hose behind the machine — A hose kinked by a pushed-back appliance or pushed too deep into a standpipe produces faults that look internal.
Owner-side steps
- Record the indication and then reset — Photograph the panel, switch off at the spur for several minutes, and restore power.
About 15 min
- Clear a child lock or delayed start — Press and hold the marked key until the symbol clears, then select a short programme.
About 5 min
- Clean the filter assembly and clear the sump — Lift out both filters, wash them under a tap and feel round the sump for debris.
Tools: brush, glovesAbout 25 min
- STOP at the point where a panel would have to come off — Everything beyond that point is diagnosed on an unplugged appliance with test equipment.
Read this before starting
Safety
Unplug the appliance or switch off its breaker, close the water supply, and let the pressure out of the hoses before opening anything. A capacitor keeps its charge after the power is gone, and an inlet hose under house pressure does not empty politely. If the floor is already wet, deal with the breaker before you step in it.
When to call a technician
The line is the control fascia: settings, resets, filters and taps are homeowner work, and the panel is not. Call when you have run out of checks that cost nothing, which is usually the honest end of an homeowner sequence.
Related pages of the same kind
Scope of this page
A generalized page has generalized limits. It does not cover any one family, chassis or model year, and it does not carry part numbers, wiring identification or factory service codes; those live on the specific pages, and where such a page exists for your unit it is linked from here and takes precedence over what you read above. Nothing here should be read as the service procedure for a specific chassis. It also does not cover installation faults that look like appliance faults, which are handled on the pages for the problem they imitate.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
