The short answer
When a Candor BC refrigerator leaks, resist the urge to mop and re-check. Find the origin first — inside, front, or back — because the fix for each is different and two of the three need the water supply closed before anything is opened. The matrix below names a single model tag for this family, so there is no revision fork to work around: what holds for that tag holds for the whole line.
What you can observe on these models
- A sheet of ice under the crisper drawers — That is defrost melt that froze where it stopped. It is the signature of a blocked drain and it will keep rebuilding until the drain is cleared.
- Water running down the inside of the rear wall — Melt escaping the trough rather than entering it. Same origin as the ice above, caught a little earlier.
- Condensation on the inner surfaces and a damp smell — A seal that is not closing or a door being left ajar lets room air in; it condenses, runs, and eventually pools. It looks like a leak and is a door problem.
- NEAR MISS — water only after the ice bin is used — Melt from a bin that is being over-filled or from a dispenser chute that is not sealing is an ice-system fault, not a drain fault.
Causes, most likely first on this family
- A blocked defrost drain — First. Every frost-free cabinet makes defrost water on a schedule, so the drain is a wear item in a way no other part on this page is. A blocked drain is the default explanation for interior water until something else is proven.
- A door seal that is not closing, or a door left ajar — Second on this line: it is quick to check, it explains water that appears in several places at once, and it is often the reason a drain blocked in the first place.
- The drain pan cracked, displaced, or overflowing — Third, and the most common origin for a front puddle with a dry interior. Pulling the unit out and looking is the whole test.
- Ice-maker fill overshoot or a dispenser chute that does not seal — Last, and it is a diagnosis of exclusion. If the drain is clear, the seals close, the pan is sound and the supply is dry, the fill circuit is what remains.
Check in this order, and why
- Find where the water starts, not where it collects — Interior, front kick plate, or behind the unit — those three origins have almost no overlap, and each points at a different set of parts. Dry everything, run the cabinet, and watch where it comes back.
- Clear and test the defrost drain — The trough behind the bottom of the rear freezer panel should take a slow pour of warm water and deliver it to the pan. If it backs up, that is the fault, and clearing it is owner work.
- Close each door on a sheet of paper and pull — A seal that lets the paper slide out without resistance is not closing there. Do it at several points around each door; one bad corner is enough to condense a puddle.
Before you open anything
Safety
Disconnect the power before any panel comes off; a capacitor can hold a charge after the power is off. Shut the water supply at the tap before opening a fitting and keep towels under the work. Thaw a frozen drain rather than forcing it — a stiff wire through a trough can puncture the tubing running behind it, and that converts a free repair into a sealed-system job.
Models this page covers
Reference| Model number | Family key |
|---|---|
| BC-60 | candor:refrigerator:bc |
When to call a technician
The owner line here is the drain, the seal and the pan. It is crossed when the water is coming from the valve, when the drain blocks again within weeks, or when the interior is icing faster than defrost can clear it — all three need the compartment opened and measured rather than mopped. Any leak that has reached an electrical outlet or a floor void is a same-day call regardless of origin.
Other faults covered for this family
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
