The short answer
A new noise on a WGB washer usually has something loose in it - a coin in the sump, an underwired load, or a machine that has walked on its feet since the last wash. The drum bearing is real, but it is the last suspect rather than the first.
What you observe
- A squeal on the first rotation of every wash — Usually the door seal or a belt taking up its slack rather than anything structural.
- The machine walks across the floor on spin — Feet, floor or load. The noise is a symptom of the movement, and stopping the movement stops the noise.
- Loud only on one programme — Different programmes use different spin speeds, so this normally means the noise has a speed threshold rather than a cause of its own.
- A humming machine that does not turn at all — The motor is being asked to move a drum that will not move, and that is a jammed-drum fault rather than a noise fault.
- A metallic rattle at low drum speed — Something loose is riding in the drum or has passed the seal into the sump. It is audible at slow speeds because nothing is masking it.
Ranked causes for these models
- Unbalanced or under-loaded drum — First on this family by frequency: a small heavy item alone in a large drum cannot be balanced, so the machine either bangs or refuses to reach speed.
- Drain pump impeller fouled — Produces a harsh noise on drain only, which is why the timing of the noise within the cycle matters so much on this diagnosis.
- Transit bolts still fitted or partly backed off — Only on a machine that has been moved, but on such a machine it is the very first thing to check and the noise is unmistakable.
- Foreign object in the sump or between drum and tub — Coins, wires and clips pass the seal and grind continuously. It ranks high here because it is common and because it does real damage if left.
The diagnostic order for these models
- Listen for whether the noise tracks drum speed — Speed-tracking noise is mechanical and in the rotating assembly; constant noise is not, and that split is the most useful one you can make.
- Run a spin with the drum empty — It removes the load variable entirely, which is the single biggest source of noise on this family, and it costs one short cycle.
- Rock the cabinet at each corner — Any movement means a foot is not carrying weight, and everything downstream of that is unreliable until it is fixed.
- Press and release each cabinet panel while the noise runs — A rattle that changes under your hand is panel resonance and needs no part at all.
Power down first
Safety
Disconnect the plug before servicing, and put a towel and a shallow tray under the filter door. There is always water left in the sump even when the display says the cycle finished.
Models in the WGB family
Reference| Model number | Family key |
|---|---|
| WGB24600UC | bosch:washer:wgb |
| WGB24609AU | bosch:washer:wgb |
| WGB246AXUC | bosch:washer:wgb |
| WGB25600AU | bosch:washer:wgb |
| WGB25601AU | bosch:washer:wgb |
| WGB256A1AU | bosch:washer:wgb |
| WGB256A2AU | bosch:washer:wgb |
When this becomes a service call
Book a visit when the same fault returns after a correct repair. A repeat failure on these machines usually means a second fault upstream, and chasing it from the outside costs more weekends than it saves.
Nearest pages of this class
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
