The short answer
Before assuming the worst on the TF family, rule out the two impostors: a machine set to a power level far below full, and a machine running a mode that was never meant to heat. Once those are eliminated on the six models below, a cold cycle means the high-voltage section, and the cabinet stays on.
What you observe on these models
- The cycle runs normally and the food is cold at the end — Light, turntable, fan and timer all working; no heat produced at all.
- A cup of water is no warmer after two minutes — The standard test, and far more reliable than judging by a plate of food.
- A loud hum or buzz during the cycle — The high-voltage section trying and failing, which is diagnostic and still not owner-repairable.
- It heats weakly rather than not at all — Partial output, and it often arrives before total failure.
- NEAR MISS - it will not start at all — That is the start page for the TF family, and much of it is owner-checkable.
Causes, most likely first on the TF family
- The high-voltage section — First on the TF family and effectively the whole page. When the control side works and nothing heats, output has stopped, and every part that produces it sits behind the cabinet beside a capacitor that can hold a lethal charge after unplugging.
- Power level or mode set low — Second, and the only cause an owner can fix. A machine left on a low power setting or in a mode that does not heat produces exactly this complaint.
- A door interlock that is marginal — Third. An interlock chain that is not quite made can leave the machine running the display and not the output.
- Supply voltage or a shared circuit under load — Last, and uncommon, but free to test by trying the appliance on a different circuit.
Check in this order, and why
- First: run the water test — A mug of cold water, two minutes at full power, and feel it. This replaces every impression of how the food came out.
- Second: check the power level and the mode — Reset the appliance to full power and a plain cook mode rather than whatever was last used.
- Third: try another outlet if it is a countertop model — Free, quick, and it eliminates a marginal supply as a cause.
- Fourth: stop — Do not remove the cabinet on the six models below. The capacitor inside can hold a lethal charge long after the appliance is unplugged, and waiting does not discharge it.
Before you open anything
Safety
Unplug the microwave before doing anything other than looking at it, and do not remove the cabinet under any circumstances: the capacitor inside can hold a lethal charge long after the appliance is unplugged, and it does not discharge by being left. Never run one of the six models below empty to test it - with nothing to absorb the output, that damages the appliance.
Models in the TF family
Reference| Model number | Family key |
|---|---|
| TF044E6T-SHNNE0 | bosch:microwave:tf |
| TF044E6V-S0MAK1 | bosch:microwave:tf |
| TF044E6V-S0NAK1 | bosch:microwave:tf |
| TF044E6V-S0NNK1 | bosch:microwave:tf |
| TF044E6V-SHNNK1 | bosch:microwave:tf |
| TF044EU6-SH0AE0 | bosch:microwave:tf |
When to call a technician
Everything on the owner side of the six models below takes about five minutes: power level, mode, water test, another outlet. After that it is a technician, and the cabinet stays on until they arrive. Call immediately rather than continuing to use it if there is any smell, spark or unusual noise alongside the cold food.
Other faults covered for the TF family
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
