The short answer
An Asko washer that will not start after a move or a power cut is usually in a recoverable state rather than broken. After a cut, drain the drum if necessary and give the machine a genuine power cycle of several minutes. After a move, check the transit bolts, the levelling and both hose connections before pressing anything.
Symptoms, and the ones that mean something else
- Dead or unresponsive immediately after a power cut — A latched control state. A proper power cycle usually clears it.
- Door locked with water inside after a cut — The machine will not release the door onto a full drum. Drain it first.
- Violent movement or refusal to spin after a move — Transit bolts still fitted, or a machine that is not level.
- No fill after a move — A tap left closed or a hose reconnected badly.
- NEAR MISS: the machine simply switched off at the wall during the move — It happens more often than anything on this list.
The ranking that matters
- A latched control state after a supply interruption — First after a power cut, and it clears with a full power cycle.
- Water remaining in the drum holding the door — Second, and it is the machine behaving correctly.
- Transit bolts fitted or partly fitted — First after a move, and it locks the drum solid.
- Hoses or tap not reconnected properly — Second after a move, and it stops the fill.
- A protective device tripped by the interruption — Present in both cases, and free to check.
What to look at first
- Establish which event preceded it — A move and a power cut point at different things entirely.
- Check the consumer unit — An interruption often leaves a device off.
- After a move: check for transit bolts at the rear — They lock the drum and they are easy to forget.
- After a cut: power down fully for several minutes — A genuine reset, not a quick flick.
Steps up to the stopping point
- Check every protective device in the consumer unit — Reset once; a second trip means an electrician rather than a technician.
Tools: torchAbout 10 min
- Switch the machine off at the wall for several minutes, then restore — A brief flick does not clear a latched state; a proper interval does.
About 10 min
- After a move, check the rear for transit bolts and remove them — They are fitted for transport and must come out before the machine runs. Keep them for the next move.
Tools: spannerAbout 20 min
- Check the tap is open, the inlet hose is tight and the machine is level — Reconnection faults after a move are commoner than component failures. Stop here rather than opening the cabinet.
Tools: spirit level, spannerAbout 25 min
Power off, panels later
Safety
Unplug the appliance or switch off its breaker before removing any panel — a capacitor can hold a charge after the power is off. Never force a locked door: if water remains in the drum it empties across the floor and the catch and interlock are both damaged. Drain through the small hose behind the filter flap into a shallow tray first. A washing machine is heavy and awkward: get help moving it, and never lift one by the door or the fascia.
When to call a technician
Call when the machine has had a genuine power cycle, the consumer unit is clear and it still will not start. Call after a move when the transit bolts are out, the hoses are right and the machine is level and it still refuses. Say which event preceded the fault when you book, because a post-move fault and a post-cut fault need different preparation. Call an electrician if a device trips again on reset.
Same problem, other brands
Scope of this page
This page is the class-level answer for an Asko washer that will not start after a move or a power interruption. It publishes no transit-bolt part numbers, error codes or board identifiers, because those differ between builds under this badge. Where a family- or model-specific page exists it carries the references for that machine. Water supply, drainage, levelling and the laundry circuit belong to the installation rather than to the appliance.
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
