The short answer for Artt ATED
For the models listed under Artt ATED, a refusal to start is most often a broken drive belt or a seized drum. The generic article for this brand puts the emphasis elsewhere; the roster below is why this page does not. Of the four causes ranked below, three are owner work and the remainder need a technician.
What you observe on these models
- The machine runs only while the start button is held in — A classic worn start switch or a motor that is not latching into its run winding.
- Nothing at all happens when start is pressed — No display, no hum, no click — which points at supply rather than at the machine.
- A click from the door area each time start is pressed, and nothing else
- The breaker trips the moment start is pressed
- NEAR MISS — the drum turns but nothing gets warm — That is a heating fault, and it has a page of its own; the machine is starting correctly here.
Causes, most likely first on Artt ATED
- A broken drive belt or a seized drum — The motor runs and the drum does not, or the motor hums against a drum it cannot turn. Both are mechanical and both are audible. It earns this place because a seized bearing gives a hum and a trip instead, which is the more urgent version of the same fault.
- The door switch or latch not making — Placed at this point because it is the single most common reason a powered, lit machine refuses to turn its drum, and it is operated thousands of times over the machine life.
- Power supply: breaker, outlet or cord — It is here because a double breaker for a large-appliance circuit can trip on one half and still look switched on.
- The control board or the motor itself — A control that never energises the motor, or a motor whose windings have opened, on a machine whose supply, door and drive train are all proven. Ranked here because both need a meter on live terminals, so this is where the diagnosis leaves the owner.
Check in this order, and why
- With the power off, turn the drum by hand — A drum that spins with no resistance at all suggests a broken belt; one that will not move at all suggests a seized bearing or an obstruction.
- Press the door firmly shut and press start again — A machine that starts when the door is held is telling you exactly where the fault is.
- Why this order and not another — It follows the ranking, not a generic checklist: on Artt ATED the first check separates a broken drive belt or a seized drum from the door switch or latch not making, and access decides the rest — what this family puts behind which panel is why the cheap check comes first.
What to isolate before a panel comes off
Safety
Unplug the appliance or switch off its breaker before removing any panel. A capacitor can hold a charge after the power is off. A laundry machine keeps mains voltage at the motor, the drive board and the heat circuit whatever the display shows, so the plug and the breaker are the only real isolation. If you smell gas: do not switch anything on or off, leave the building, and call the gas utility or 911 from outside. Do not look for the leak yourself.
Models in the ATED family
Reference| Model number | Family key |
|---|---|
| ATED67 | artt:dryer:ated |
| ATED70U | artt:dryer:ated |
When to call a technician
Stop and call once you have reset the breaker fully, confirmed the outlet is live, pressed the door firmly and turned the drum by hand, and the machine is still dead. Call first, before any of that, if the machine had been drying slowly or running hot before it died — that history points at a thermal fuse and at a duct that has to be cleared in the same visit.
Other problems covered for Artt ATED
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
