The short answer for Artt ATED
The Artt ATED family answers this differently from the brand as a whole: here a foreign object in the drum seam or the blower ranks ahead of the motor or the blower wheel itself, because of how these models are built and how they are reached. The first checks cost nothing, and two of the four causes listed here can be settled without a meter.
What you observe on these models
- A scraping or grinding from the front or rear of the drum — Worn glides or a drum riding on its seal, which will wear through the drum lip if it is left.
- A roar or a whine that is loudest at the back of the machine — The blower wheel, which sits in the exhaust path and takes everything the lint screen misses.
- A noise that started after the machine was moved or levelled
- NEAR MISS — a hum with no drum movement at all — That is a start or drive fault and it belongs on the will-not-start page, not here.
Causes, most likely first on Artt ATED
- A foreign object in the drum seam or the blower — Coins, buttons, underwire and hair grips work their way past the drum seam into the blower housing, where they rattle against the wheel on every revolution. It sits at this point because an object in the blower gets louder as the machine speeds up and quieter as it coasts, which is a distinctive signature.
- The idler pulley or a worn belt — It earns this place because it sits behind the front or rear panel and it is a technician job on most designs.
- Worn front glides or drum felt — Placed at this point because leaving it wears the drum lip itself, which turns a cheap set of glides into a much larger job.
- The motor or the blower wheel itself — A motor bearing that has failed, or a blower wheel that has cracked on its hub, gives a roar or a knock that no amount of cleaning changes. It is here because a blower wheel loose on its hub knocks under airflow load, which is why it is often worse at the start of a cycle.
Check in this order, and why
- Turn the drum slowly by hand with the power off and listen for something loose — A click or slide as the drum turns, or an object visible in the seam, settles the diagnosis without tools.
- Note whether the squeal tracks the drum or the motor — A squeal that continues at a constant pitch while the drum slows is at the motor end, which is the idler or the blower.
- Why this order and not another — It follows the ranking, not a generic checklist: on Artt ATED the first check separates a foreign object in the drum seam or the blower from the idler pulley or a worn belt, and access decides the rest — what this family puts behind which panel is why the cheap check comes first.
Power, water and gas — in that order
Safety
Unplug the appliance or switch off its breaker before removing any panel. A capacitor can hold a charge after the power is off. Then close the hot and cold taps, because a hose or a valve that has to come off will empty a supply line into the room otherwise. If you smell gas: do not switch anything on or off, leave the building, and call the gas utility or 911 from outside. Do not look for the leak yourself.
Models in the ATED family
Reference| Model number | Family key |
|---|---|
| ATED67 | artt:dryer:ated |
| ATED70U | artt:dryer:ated |
When to call a technician
The line is the cabinet. Turning the drum by hand, clearing the seam and the lint housing and levelling the machine are owner work with the cord out; rollers, belts, idlers and blower wheels are behind panels that carry the motor and the heat circuit.
Other problems covered for Artt ATED
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
