The short answer
The brand’s guidance for F6 E2 is a longer reset than most: switch off the dryer’s circuit breaker, or breakers, for five minutes, then restore power. No part is named; if the code stays away, keep using the dryer, and if it returns, the control is reporting a fault that needs a technician.
Error codes
Reference| Code | Meaning |
|---|---|
| F6 E2 | Power unit down by turning off the circuit breaker(s) for 5 minutes. |
What the dryer does with the code showing
- The display froze with the code showing — Keys and display stop responding while the code stays up.
- The dryer will not start a new cycle — The control refuses to run until it has restarted.
- The code appeared after an outage or panel work — A power event the control did not ride through.
- NEAR MISS: the dryer tumbles but stays cold, with no code — No heat without a code is a heating or breaker question, not this reset.
Likely causes, in order
- Control that needs a complete restart — The most common reason: a control that has locked up rides through a short interruption on stored charge, so only a long power-down clears it.
- Control fault that keeps recurring — Second: a recurring fault that the reset can clear from the display but not from the dryer.
- Supply problem upstream — Third: a loose connection at the outlet, cord, terminal block or breaker that drops the supply in use.
Where to start, and what comes next
- Do the documented five-minute power-down — Breaker off for the full five minutes; a shorter wait is not the same test.
- Start a short timed dry — A simple cycle shows quickly whether the control is back to normal.
- Watch whether the code returns — Within the first load, days later or never: each tells a different story.
- Check the supply side — A warm plug, a loose breaker handle or dimming lights point upstream.
What you can safely do
- Five-minute power-down — Switch off the dryer’s circuit breaker, both handles on an electric model, and leave it off for a full five minutes before switching it back on.
Tools: watch or phone timerAbout 6 min
- Run a timed dry — Start a short timed dry and watch the display and the drum for the first few minutes.
About 15 min
- Look at the breaker and plug — Check that the breaker handles sit firmly on and, with the power off, that the plug sits fully in the outlet.
Tools: flashlightAbout 3 min
- STOP here if the next check needs a panel off — Anything behind a panel is a power-off technician job, and the tests that follow it are made on live circuits.
Power off before any panel
Safety
Unplug the appliance or switch off its breaker before removing any panel. A capacitor can hold a charge after the power is off. An electric dryer runs on a two-pole breaker, so make sure both halves are off; a gas dryer’s gas line stays live with the cord out. A breaker that trips again, feels warm or buzzes stays off: that is an electrician’s call, not another reset.
The point to call
Call when the code returns after a full five-minute power-down. If the breaker trips, the plug or outlet feels warm, or other appliances misbehave, call an electrician before the dryer technician.
Other Amana dryer codes close to this one
Which models this reading covers
Generalized information for Amana gas and electric dryers with an electronic display. It is not a reading for Amana dryers with dial-only controls, Amana washers, which share some characters but not their meanings, or sister brands on the same platform. The details that change inside the line, such as wiring colours, part numbers and connector locations, belong on model pages, and none is published for F6 E2 yet.
All Amana dryer codes
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
