The short answer
F2E2 comes with a single published step: switch off the circuit breaker feeding the dryer for one minute so the control restarts from scratch. On an electric dryer that means the whole two-pole breaker; on a gas dryer, the breaker or the plug. Dry normally if the code does not come back.
Error codes
Reference| Code | Meaning |
|---|---|
| F2E2 Error Code | Power unit down by turning off the circuit breaker(s) for one (1) minute. |
What the dryer does with the code showing
- The keys do not respond — A control that has lost its place can freeze instead of running.
- The display shows the code with the dryer idle — The fault happened between loads, not during one.
- The code comes back at the same point in a cycle — A repeat is what marks a real fault rather than a lock-up.
- NEAR MISS: the dryer runs but does not heat, with no code — No heat without a code points at the heating side or, on an electric dryer, half of its breaker.
Likely causes, in order
- Control lost its place after a power event — Most likely: a brief disturbance in the supply scrambled the control’s running state, and a full power-down lets it start clean.
- Control fault that keeps recurring — Second: when the code returns after each reset, the control or something it monitors is failing, and the reset only clears the display.
- Unstable supply to the dryer — Third: a worn breaker or a loose cord connection that starves the control intermittently.
Where to start, and what comes next
- Do the documented one-minute power-down — It is the brand’s own step, it costs nothing, and it comes before anything else.
- Note whether, and when, it returns — Back within the load points at a real fault; never again points at a power event.
- Look for supply trouble — A breaker that trips, lights that dim or a warm plug move the search to the supply.
- Book diagnosis on a second return — Two returns after clean resets mean the control is reporting something real.
What you can safely do
- One-minute power-down — Turn off every breaker that feeds the dryer, or unplug a gas model, for a full minute, then restore power.
About 2 min
- Check the breaker — Make sure the handles sit firmly on and that none feels loose or warm.
Tools: flashlightAbout 3 min
- Keep a short log — Write down what was running, how long after the reset the code returned, and anything else that glitched.
Tools: notepad or phoneAbout 2 min
- STOP before testing anything with a meter — Live-voltage checks and part tests are where the owner side of this code ends.
Power off before any panel
Safety
Unplug the appliance or switch off its breaker before removing any panel. A capacitor can hold a charge after the power is off. An electric dryer runs on a two-pole breaker, so make sure both halves are off; a gas dryer’s gas line stays live with the cord out. A breaker that trips again, feels warm or buzzes stays off: that is an electrician’s call, not another reset.
The point to call
Book a technician once the code survives a clean one-minute reset: the control is then reporting something real. A breaker that trips, buzzes or feels warm is an electrician’s job before it is a dryer repair.
Neighbouring codes
Scope of this reading
The reading above covers Amana gas and electric dryers with an electronic display. It does not cover Amana dryers with dial-only controls, Amana washers, which share some characters but not their meanings, or sister brands on the same platform. A model-specific page for F2E2, where one exists, is the more specific answer; none exists yet, so check the use-and-care guide for your exact model before ordering any part.
Browse the code list
Lead Appliance Repair Technician · 12 years experience
Experienced technician with 12 years specializing in washing machine and dryer repairs across all major brands.
